Hi Team Still struggling with tuning this card. I noticed that when this card is pluged in, it is recognised as a Freecom card. But when the firware is loaded it first disconnects, and reconnects as a Wideview. Is this normal? ================Output from dmesg================================================= usb 3-5: USB disconnect, address 3 dvb-usb: WideView/Yuan/Yakumo/Hama/Typhoon DVB-T USB2.0 (WT-200U) successfully deinitialized and disconnected. usb 3-5: new high speed USB device using ehci_hcd and address 4 dvb-usb: found a 'WideView WT-220U PenType Receiver (Typhoon/Freecom)' in cold state, will try to load a firmware dvb-usb: downloading firmware from file 'dvb-usb-wt220u-01.fw' to the 'Cypress FX2' dvb-usb: WideView WT-220U PenType Receiver (Typhoon/Freecom) successfully initialized and connected. usb 3-5: USB disconnect, address 4 dvb-usb: generic DVB-USB module successfully deinitialized and disconnected. usb 3-5: new high speed USB device using ehci_hcd and address 5 dvb-usb: found a 'WideView/Yuan/Yakumo/Hama/Typhoon DVB-T USB2.0 (WT-200U)' in warm state. dvb-usb: will use the device's hardware PID filter (table count: 15). DVB: registering new adapter (WideView/Yuan/Yakumo/Hama/Typhoon DVB-T USB2.0 (WT-200U)). DVB: registering frontend 1 (WideView USB DVB-T)... dvb-usb: schedule remote query interval to 300 msecs. dvb-usb: WideView/Yuan/Yakumo/Hama/Typhoon DVB-T USB2.0 (WT-200U) successfully initialized and connected. dvb-usb: recv bulk message failed: -110 Mike Choy http://www.acaciaclose.co.uk The home of SUSE Multimedia
