I am trying to sort out what is important to worry about and what is not. I am running: hd5000-cleanup.patch Kernel source linux-2.6.13.2 Debian unstable In my dmesg I am seeing: w83627hf 2-0290: Invalid sensor type 3; must be 1, 2, or 3435 b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully flexcop-pci: will use the HW PID filter. flexcop-pci: card revision 2 ACPI: PCI Interrupt 0000:02:02.0[A] -> GSI 20 (level, low) -> IRQ 23 DVB: registering new adapter (FlexCop Digital TV device). b2c2-flexcop: MAC address = 00:d0:d7:0e:6c:c0 b2c2-flexcop: i2c master_xfer failed b2c2-flexcop: i2c master_xfer failed b2c2-flexcop: i2c master_xfer failed mt352_read_register: readreg error (reg=127, ret==-121) b2c2-flexcop: i2c master_xfer failed i2c_readbytes: i2c read error (addr 0a, err == -121) b2c2-flexcop: found the lgdt3303 at i2c address: 0x59 DVB: registering frontend 0 (LG Electronics LGDT3303 VSB/QAM Frontend)... b2c2-flexcop: initialization of 'Air2PC/AirStar 2 ATSC 3rd generation (HD5000)' at the 'PCI' bus controlled by a 'FlexCopIIb' complete Are the "i2c master_xfer failed" messages a problem? If so, what might be causing this? In mythTV setup when I setup the card as DVB I get "Card Name: Could not get card info"...and channel scanning is a broken mess. I am trying to figure out how far back in the error messages to start trying to debug. (Since I was having other issues with dvd-apps, I am going to the end game: mythTV...maybe a bad idea.) Huge thanks in advance, Todd -------------- next part -------------- An HTML attachment was scrubbed... URL: http://www.linuxtv.org/pipermail/linux-dvb/attachments/20050927/1497b191/attachment.htm
