Taylor Jacob wrote: >I have been very busy with work today, and would have posted this earlier.. >Sorry. > >Here is the "cleaned up" patch for adding support for the Air2PC/Airstar2 HD5000 >(LGDT3303 Frontend). > >http://www.digitalregime.com/patches/hd5000-cleanup.patch > >Changes to note from the last one I submitted are: > >- I have tried to impliment the SNR for the LGDT3303 since it appears to be the >same formula for the 3302 and 3303.. > >- I have also tried to impliment the signal level based on information I was >provided by BBTI.. I am not sure if this is correct for the 3302, and it is a >unitless measure since I have no idea how it was calcualted.. I would need to >spend some time digging it spec sheets for both and see if I can come up with >something, but I only have the 3303 right now.. > >- The serial_mpeg value needed to be set to 0x04 for the demux to return data.. >I am not sure as to why but the suggested value of 0x40 didn't return any data >from teh demux. (Could this have something to do with the wiring of the >frontend to the demux?) > >- The frontend reset delay added to flexcop.c was reduced from 100 or 200ms to a >reasonable 1ms which gives adequate time for the 3303 to reset.. > >Also to note: > >I have also put together a few liner patch to make the older version of the >DVICO FusionHDTV Gold3 work.. I have one that has a LGDT3302 and has a card id >of 18ac:d800 instead of 18ac:d820 (CX88_BOARD_DVICO_FUSIONHDTV_3_GOLD_T), but >appears to be the same.. I will validate this and post this seperately.. > >Taylor > > > > >_______________________________________________ > >linux-dvb@xxxxxxxxxxx >http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb > > >
