Hi, I have Pinnacle PCTV sat CI with conax cam and valid subscriber card. I can watch FTA channels with Kaffeine but when I try to see scrambled channel I get nothing (except next output). play_internal ...done demux_ts: found ISO 639 lang: dan demux_ts: selected videoPid is scrambled; skipping... demux_ts: PID 0x0206 is scrambled! demux_ts: selected videoPid is scrambled; skipping... demux_ts: selected videoPid is scrambled; skipping... ... With MythTV I stuck when I try to tune channels. 2005-09-21 20:41:28.502 DVB#0 DVB SI Table Parser Started 2005-09-21 20:41:28.503 DVB#0 Using DVB card 0, with frontend DST DVB-S. CAM doesn't support link layer interface, Caps.slot_type=1 2005-09-21 20:41:29.801 DVB#0 ERROR - CA: Failed to initialize CI handler 2005-09-21 20:41:29.966 DVB#0 DVB Signal Monitor Starting 2005-09-21 20:41:30.546 DVB#0 DVB signal 0 | snr 0 | ber b6c1a022 | unc ac968c58 2005-09-21 20:41:31.492 DVB#0 DVB signal 0 | snr 0 | ber b6c1a022 | unc ac968c58 ... I used next versions from Gentoo portage: media-video/kaffeine-0.7.1 media-libs/xine-lib-1.1.0-r4 sys-kernel/vanilla-sources-2.6.14_rc1 (with newst DVB sources from CVS) media-tv/mythtv-0.18.1-r2 dmesg will give next output: bttv0: Bt878 (rev 17) at 0000:02:09.0, irq: 23, latency: 32, mmio: 0xdb000000 bttv0: detected: Pinnacle PCTV SAT CI [card=113], PCI subsystem ID is 11bd:0026 bttv0: using: Twinhan DST + clones [card=113,autodetected] bttv0: gpio: en=00000000, out=00000000 in=00f300fd [init] bttv0: using tuner=4 bttv0: add subdevice "dvb0" bt878: AUDIO driver version 0.0.0 loaded bt878: Bt878 AUDIO function found (0). PCI: Enabling device 0000:02:09.1 (0004 -> 0006) ACPI: PCI Interrupt 0000:02:09.1[A] -> GSI 21 (level, low) -> IRQ 23 bt878(0): Bt878 (rev 17) at 02:09.1, irq: 23, latency: 32, memory: 0xda800000 Real Time Clock Driver v1.12 ohci_hcd: 2005 April 22 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI) b44: eth0: Link is up at 100 Mbps, full duplex. b44: eth0: Flow control is on for TX and on for RX. NET: Registered protocol family 10 Disabled Privacy Extensions on device c0414260(lo) IPv6 over IPv4 tunneling driver Linux agpgart interface v0.101 (c) Dave Jones [drm] Initialized drm 1.0.0 20040925 ACPI: PCI Interrupt 0000:01:00.0[A] -> GSI 16 (level, low) -> IRQ 17 [drm] Initialized r128 2.5.0 20030725 on minor 0: eth0: no IPv6 routers present dvb_bt8xx: identified card0 as bttv0 DVB: registering new adapter (bttv0). dst_get_device_id: Recognise [DSTMCI] DST type flags : 0x1 newtuner 0x10 firmware version = 2 dst_ca_attach: registering DST-CA device DVB: registering frontend 0 (DST DVB-S)... dvb_bt8xx: start_feed dvb_bt8xx: start_feed dvb_bt8xx: start_feed dvb_bt8xx: stop_feed dvb_bt8xx: stop_feed dvb_bt8xx: stop_feed dvb_bt8xx: start_feed dvb_bt8xx: start_feed dvb_bt8xx: start_feed dvb_bt8xx: start_feed dvb_bt8xx: stop_feed dvb_bt8xx: stop_feed dvb_bt8xx: stop_feed dvb_bt8xx: stop_feed dst_ca_open: Device opened [efe82d80] dst_ca_ioctl: Getting Slot capabilities put_checksum: Computing string checksum. put_checksum: -> string length : 0x07 put_checksum: -> checksum : 0xb5 dst_put_ci: Put Command ca_get_slot_caps: -->dst_put_ci SUCCESS ! ca_get_slot_caps: Slot cap = [1] =================================== 10 64 0 0 2 3 0 1 dst_ca_ioctl: -->CA_GET_CAP Success ! dst_ca_release: Device closed. dst_ca_open: Device opened [efe82d80] dst_ca_ioctl: Getting Slot capabilities put_checksum: Computing string checksum. put_checksum: -> string length : 0x07 put_checksum: -> checksum : 0xb5 dst_put_ci: Put Command ca_get_slot_caps: -->dst_put_ci SUCCESS ! ca_get_slot_caps: Slot cap = [1] =================================== 10 64 0 0 2 3 0 1 dst_ca_ioctl: -->CA_GET_CAP Success ! dst_ca_release: Device closed. dst_ca_open: Device opened [f41b5280] dst_ca_ioctl: Getting Slot capabilities put_checksum: Computing string checksum. put_checksum: -> string length : 0x07 put_checksum: -> checksum : 0xb5 dst_put_ci: Put Command ca_get_slot_caps: -->dst_put_ci SUCCESS ! ca_get_slot_caps: Slot cap = [1] =================================== 10 64 0 0 2 3 0 1 dst_ca_ioctl: -->CA_GET_CAP Success ! dst_ca_release: Device closed. dst_ca_open: Device opened [f41b5280] dst_ca_ioctl: Getting Slot capabilities put_checksum: Computing string checksum. put_checksum: -> string length : 0x07 put_checksum: -> checksum : 0xb5 dst_put_ci: Put Command ca_get_slot_caps: -->dst_put_ci SUCCESS ! ca_get_slot_caps: Slot cap = [1] =================================== 10 64 0 0 2 3 0 1 dst_ca_ioctl: -->CA_GET_CAP Success ! dst_ca_release: Device closed. Is there any suggestons how I can solve these problems? Regs, Marko
