Hi, Andy
It might be that case that it works for your card too. I think the
best is to give it a try ;-)
Best regards
Hartmut
Andy wrote:
> Cool, nice job Nick!
>
> Do you (or someone else) know if this little mod will work for T200 cards
> (placed under the T200 'case' statement of course though)? I'd have thought
> they are fairly similar and would therefore use the same key masks...?
>
> Thanks,
>
> Andy
>
>
> ----- Original Message -----
> From: <nick@xxxxxxxxxxxxx>
> To: <linux-dvb@xxxxxxxxxxx>
> Sent: Wednesday, September 21, 2005 7:31 AM
> Subject: [linux-dvb] RE: Compro DVB-T300 Remote
>
>
>
>>After much trial and error I've managed to get the remote to work.
>>
>>I don't know how to create patches etc... just yet so I've included the
>>mod's I've made to the saa7134-cards.c and the saa7134-input.c files to
>>get this to work.
>>
>>
>>saa7134-cards.c
>>Below the switch (dev->board) { line I added the following
>>
>> case SAA7134_BOARD_VIDEOMATE_DVBT_300:
>>
>>saa7134-input.c
>>Below the switch (dev->board) { line I added the following
>>
>> case SAA7134_BOARD_VIDEOMATE_DVBT_300:
>> ir_codes = videomate_tv_pvr_codes;
>> mask_keycode = 0x003F00;
>> mask_keyup = 0x040000;
>> break;
>>
>>Once I loaded the saa7134 module I was able to use evdev to see that the
>>keypresses were corresponding to the correct buttons.
>>
>>I then grabbed the lirc.conf file from bytesex and created a lircrc file.
>>
>>Changed lirc to use --driver=dev/input --device=/dev/input/event1 (or what
>>ever your IR points to) and then started irxevent. Ran Myth and everything
>>is now working beautifully.
>>
>>I'm not sure if this is 100% because I basically used trial and error to
>>get the result but it does work for me :)
>>
>>Cheers
>>
>>Nick
>>
>>_______________________________________________
>>
>>linux-dvb@xxxxxxxxxxx
>>http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
>>
>
>
>
> _______________________________________________
>
> linux-dvb@xxxxxxxxxxx
> http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
>
