Hi!
I build the DVB driver into Debian kernel and i build the DVB Starbox
driver
with Opensuse and get them up and running with insmod.sh.
But on both Distributions I can`t scan/receive channels.
My dmesg output:
dvb_usb_vp702x: module not supported by Novell, setting U taint flag.
dvb-usb: found a 'TwinhanDTV StarBox DVB-S USB2.0 (VP7021)' in cold
state, will try to load a firmware
dvb-usb: downloading firmware from file 'dvb-usb-vp702x-01.fw' to the
'Cypress FX2'
dvb-usb: TwinhanDTV StarBox DVB-S USB2.0 (VP7021) successfully
initialized and connected.
usbcore: registered new driver dvb-usb-vp702x
usb 4-1: USB disconnect, address 4
dvb-usb: generic DVB-USB module successfully deinitialized and
disconnected.
usb 4-1: new high speed USB device using ehci_hcd and address 5
dvb-usb: found a 'TwinhanDTV StarBox DVB-S USB2.0 (VP7021)' in warm
state.
dvb-usb: will use the device's hardware PID filter (table count: 8).
DVB: registering new adapter (TwinhanDTV StarBox DVB-S USB2.0 (VP7021)).
dvb-usb: MAC address: 00:08:ca:15:50:9f
vp702x: system string: USB702X
DVB: registering frontend 0 (Twinhan DST-like frontend (VP7021/
VP7020) DVB-S)...
input.c: calling hotplug without a hotplug agent defined
dvb-usb: schedule remote query interval to 400 msecs.
dvb-usb: TwinhanDTV StarBox DVB-S USB2.0 (VP7021) successfully
initialized and connected.
Drivers and frontend are loaded but Kaffeine and dvb-tools don`t find
channels.
Kaffeine output:
DVB 1 : No such device
DVB 2 : No such device
DVB 3 : No such device
Card 0 : opened ( Twinhan DST-like frontend (VP7021/VP7020) DVB-S )
Card 1 :openFe :: No such device
Card 2 :openFe :: No such device
Card 3 :openFe :: No such device
linux:~ # Using DVB card "Twinhan DST-like frontend (VP7021/VP7020)
DVB-S"
tuning DVB-S to 12551000 v 22000000
inv:2 fecH:5
DiSEqC: switch pos 0, 13V, hiband (index 2)
DiSEqC: e0 10 38 f1 00 00
polling....
Getting frontend event
polling....
Getting frontend event
Event: Frequency: 12551000
SymbolRate: 22000000
FEC_inner: 5
Transponders : 1/1
Invalid section length or timeout : pid=17
Invalid section length or timeout : pid=0
Invalid section length or timeout : pid=16
Transponders : 1
dvbsi : The end :)
Dmesg output:
vp702x: usb in operation failed.
Is this a driver problem?
My System: Mac Mini with USB 2.0, Twinhan Starbox.
Regards.
Adi
