If I run a scan as follows: ./scan dvb-t/uk-CrystalPalace I get a list of _write_dst errors in dmesg and get "tuning failed" during the scan. The results of the scan are as follows: ====== scanning dvb-t/uk-CrystalPalace using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' initial transponder 505833333 0 3 0 1 0 0 0 >>> tune to: 505833333:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_3_4:FEC_NONE:QAM_16:TRANSMISSION_MODE_2K:GUARD_INTERVAL_1_32:HIERARCHY_NONE WARNING: >>> tuning failed!!! >>> tune to: 505833333:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_3_4:FEC_NONE:QAM_16:TRANSMISSION_MODE_2K:GUARD_INTERVAL_1_32:HIERARCHY_NONE (tuning failed) WARNING: >>> tuning failed!!! ERROR: initial tuning failed dumping lists (0 services) Done. ====== The errors in dmesg (occurring during a scan) look like: ====== write_dst: _write_dst error (err == -5, len == 0x08, b0 == 0x07) ...<repeated lots of times>... ====== Any ideas what this means? Card details: ====== Twinhan DVB-T Mini Ter bttv: driver version 0.9.15 loaded bttv: using 8 buffers with 2080k (520 pages) each for capture bttv: Bt8xx card found (0). ACPI: PCI Interrupt 0000:00:14.0[A] -> Link [LNKB] -> GSI 10 (level, low) -> IRQ 10 bttv0: Bt878 (rev 17) at 0000:00:14.0, irq: 10, latency: 32, mmio: 0xde003000 bttv0: detected: Twinhan VisionPlus DVB [card=113], PCI subsystem ID is 1822:0001 bttv0: using: Twinhan DST + clones [card=113,autodetected] bttv0: gpio: en=00000000, out=00000000 in=00f500ff [init] bttv0: using tuner=4 bttv0: add subdevice "dvb0" bt878: AUDIO driver version 0.0.0 loaded bt878: Bt878 AUDIO function found (0). ACPI: PCI Interrupt 0000:00:14.1[A] -> Link [LNKB] -> GSI 10 (level, low) -> IRQ 10 bt878(0): Bt878 (rev 17) at 00:14.1, irq: 10, latency: 32, memory: 0xde004000 DVB: registering new adapter (bttv0). dst_get_device_id: Recognise [DTTDIG] DST type : terrestrial DST type flags : 0x10 firmware version = 2 DVB: registering frontend 0 (DST DVB-T)... ====== Any assistance appreciated. Kind regards, Elliot.
