Re: [PATCH v5 15/39] [media] v4l2: add a frame interval error event

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Hans,

On 03/10/2017 04:03 AM, Hans Verkuil wrote:
On 10/03/17 05:52, Steve Longerbeam wrote:
Add a new FRAME_INTERVAL_ERROR event to signal that a video capture or
output device has measured an interval between the reception or transmit
completion of two consecutive frames of video that is outside the nominal
frame interval by some tolerance value.

Reading back what was said on this I agree with Sakari that this doesn't
belong here.

Userspace can detect this just as easily (if not easier) with a timeout.



Unfortunately measuring frame intervals from userland is not accurate
enough for i.MX6.

The issue here is that the IPUv3, specifically the CSI unit, can
permanently lose vertical sync if there are truncated frames sent
on the bt.656 bus. We have seen a single missing line of video cause
loss of vertical sync. The only way to correct this is to shutdown
the IPU capture hardware and restart, which can be accomplished
simply by restarting streaming from userland.

There are no other indicators from the sensor about these short
frame events (believe me, we've exhausted all avenues with the ADV718x).
And the IPUv3 DMA engine has no status indicators for short frames
either. So the only way to detect them is by measuring frame intervals.

The intervals have to be able to resolve a single line of missing video.
With a PAL video source that requires better than 58 usec accuracy.

There is too much uncertainty to resolve this at user level. The
driver is able to resolve this by measuring intervals between hardware
interrupts as long as interrupt latency is reasonably low, and we
have another method using the i.MX6 hardware input capture support
that can measure these intervals very accurately with no errors
introduced by interrupt latency.

I made this event a private event to imx-media driver in a previous
iteration, so I can return it to a private event, but this can't be
done at user level.

Steve




Signed-off-by: Steve Longerbeam <steve_longerbeam@xxxxxxxxxx>
---
 Documentation/media/uapi/v4l/vidioc-dqevent.rst | 6 ++++++
 Documentation/media/videodev2.h.rst.exceptions  | 1 +
 include/uapi/linux/videodev2.h                  | 1 +
 3 files changed, 8 insertions(+)

diff --git a/Documentation/media/uapi/v4l/vidioc-dqevent.rst b/Documentation/media/uapi/v4l/vidioc-dqevent.rst
index 8d663a7..dc77363 100644
--- a/Documentation/media/uapi/v4l/vidioc-dqevent.rst
+++ b/Documentation/media/uapi/v4l/vidioc-dqevent.rst
@@ -197,6 +197,12 @@ call.
 	the regions changes. This event has a struct
 	:c:type:`v4l2_event_motion_det`
 	associated with it.
+    * - ``V4L2_EVENT_FRAME_INTERVAL_ERROR``
+      - 7
+      - This event is triggered when the video capture or output device
+	has measured an interval between the reception or transmit
+	completion of two consecutive frames of video that is outside
+	the nominal frame interval by some tolerance value.
     * - ``V4L2_EVENT_PRIVATE_START``
       - 0x08000000
       - Base event number for driver-private events.
diff --git a/Documentation/media/videodev2.h.rst.exceptions b/Documentation/media/videodev2.h.rst.exceptions
index e11a0d0..c7d8fad 100644
--- a/Documentation/media/videodev2.h.rst.exceptions
+++ b/Documentation/media/videodev2.h.rst.exceptions
@@ -459,6 +459,7 @@ replace define V4L2_EVENT_CTRL event-type
 replace define V4L2_EVENT_FRAME_SYNC event-type
 replace define V4L2_EVENT_SOURCE_CHANGE event-type
 replace define V4L2_EVENT_MOTION_DET event-type
+replace define V4L2_EVENT_FRAME_INTERVAL_ERROR event-type
 replace define V4L2_EVENT_PRIVATE_START event-type

 replace define V4L2_EVENT_CTRL_CH_VALUE ctrl-changes-flags
diff --git a/include/uapi/linux/videodev2.h b/include/uapi/linux/videodev2.h
index 45184a2..cf5a0d0 100644
--- a/include/uapi/linux/videodev2.h
+++ b/include/uapi/linux/videodev2.h
@@ -2131,6 +2131,7 @@ struct v4l2_streamparm {
 #define V4L2_EVENT_FRAME_SYNC			4
 #define V4L2_EVENT_SOURCE_CHANGE		5
 #define V4L2_EVENT_MOTION_DET			6
+#define V4L2_EVENT_FRAME_INTERVAL_ERROR		7
 #define V4L2_EVENT_PRIVATE_START		0x08000000

 /* Payload for V4L2_EVENT_VSYNC */



_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel



[Index of Archives]     [Linux Driver Backports]     [DMA Engine]     [Linux GPIO]     [Linux SPI]     [Video for Linux]     [Linux USB Devel]     [Linux Coverity]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux