This member of the private data is not needed. We can check if
dev->irq is none zero instead. Remove it.
Signed-off-by: H Hartley Sweeten <hsweeten@xxxxxxxxxxxxxxxxxxx>
Cc: Ian Abbott <abbotti@xxxxxxxxx>
Cc: Greg Kroah-Hartman <gregkh@xxxxxxxxxxxxxxxxxxx>
---
drivers/staging/comedi/drivers/pcl818.c | 10 +++-------
1 file changed, 3 insertions(+), 7 deletions(-)
diff --git a/drivers/staging/comedi/drivers/pcl818.c b/drivers/staging/comedi/drivers/pcl818.c
index cacdca0..3dac1dd 100644
--- a/drivers/staging/comedi/drivers/pcl818.c
+++ b/drivers/staging/comedi/drivers/pcl818.c
@@ -274,7 +274,6 @@ struct pcl818_private {
unsigned char neverending_ai; /* if=1, then we do neverending record (you must use cancel()) */
unsigned int ns_min; /* manimal allowed delay between samples (in us) for actual card */
int i8253_osc_base; /* 1/frequency of on board oscilator in ns */
- int irq_free; /* 1=have allocated IRQ */
int irq_blocked; /* 1=IRQ now uses any subdev */
int irq_was_now_closed; /* when IRQ finish, there's stored int818_mode for last interrupt */
int ai_mode; /* who now uses IRQ - 1=AI1 int, 2=AI1 dma, 3=AI3 int, 4AI3 dma */
@@ -701,8 +700,7 @@ static irqreturn_t interrupt_pcl818(int irq, void *d)
outb(0, dev->iobase + PCL818_CLRINT); /* clear INT request */
- if ((!dev->irq) || (!devpriv->irq_free) || (!devpriv->irq_blocked)
- || (!devpriv->ai_mode)) {
+ if (!dev->irq || !devpriv->irq_blocked || !devpriv->ai_mode) {
comedi_error(dev, "bad IRQ!");
return IRQ_NONE;
}
@@ -1230,10 +1228,8 @@ static int pcl818_attach(struct comedi_device *dev, struct comedi_devconfig *it)
if ((1 << it->options[1]) & board->IRQbits) {
ret = request_irq(it->options[1], interrupt_pcl818, 0,
dev->board_name, dev);
- if (ret == 0) {
+ if (ret == 0)
dev->irq = it->options[1];
- devpriv->irq_free = 1;
- }
}
devpriv->irq_blocked = 0; /* number of subdevice which use IRQ */
@@ -1242,7 +1238,7 @@ static int pcl818_attach(struct comedi_device *dev, struct comedi_devconfig *it)
/* grab our DMA */
dma = 0;
devpriv->dma = dma;
- if (!devpriv->irq_free)
+ if (!dev->irq)
goto no_dma; /* if we haven't IRQ, we can't use DMA */
if (board->DMAbits != 0) { /* board support DMA */
dma = it->options[2];
--
1.8.4.4
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
