On Tue, Oct 29, 2013 at 1:00 PM, Fabio Estevam <festevam@xxxxxxxxx> wrote:
> Today I was able to get access to a wandboard solo and the HDMI image
> does look different compared to a wandboard quad board:
>
> - The Linux logo penguins are steady on mx6q, but on mx6solo the
> contour lines look like they flicker.
> - The kernel log text appears in good white colour with mx6q, but not
> so white on mx6solo (tending to green).
>
> Even the U-boot HDMI splash screen is not very steady on mx6solo.
>
> I will try to look at these mx6 solo HDMI issues.
With the change below I am able to get a good HDMI quality image on
mx6solo (and mx6quad as well):
--- a/drivers/staging/imx-drm/ipuv3-crtc.c
+++ b/drivers/staging/imx-drm/ipuv3-crtc.c
@@ -238,7 +238,7 @@ static int ipu_crtc_mode_set(struct drm_crtc *crtc,
sig_cfg.Vsync_pol = 1;
sig_cfg.enable_pol = 1;
- sig_cfg.clk_pol = 0;
+ sig_cfg.clk_pol = 1;
sig_cfg.width = mode->hdisplay;
sig_cfg.height = mode->vdisplay;
sig_cfg.pixel_fmt = out_pixel_fmt;
Regards,
Fabio Estevam
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
