Am 08.06.2013 09:25, wrote Steffen Trumtrar:
> Hi Shawn!
>
> On Sat, Jun 08, 2013 at 12:49:47PM +0800, Shawn Guo wrote:
>> On Fri, Jun 07, 2013 at 10:37:08AM +0200, Steffen Trumtrar wrote:
>>> From: Markus Niebel <Markus.Niebel@xxxxxx>
>>>
>>> Since 18 bit is supported as datawidth in device tree it should be
>>> supported in driver. Beside the LDB channel the IPU channel has also
>>> to be configured to use BGR666.
>>>
>>> Signed-off-by: Markus Niebel <Markus.Niebel@xxxxxx>
>>> Signed-off-by: Steffen Trumtrar <s.trumtrar@xxxxxxxxxxxxxx>
>>> ---
>>> This is based on the series: "staging: drm/imx: Add LDB support"
>>> by Philipp.
>>>
>>>
>>> drivers/staging/imx-drm/imx-ldb.c | 18 +++++++++++++++++-
>>> 1 file changed, 17 insertions(+), 1 deletion(-)
>>>
>>> diff --git a/drivers/staging/imx-drm/imx-ldb.c b/drivers/staging/imx-drm/imx-ldb.c
>>> index d8fc93c..84bf7d3 100644
>>> --- a/drivers/staging/imx-drm/imx-ldb.c
>>> +++ b/drivers/staging/imx-drm/imx-ldb.c
>>> @@ -179,6 +179,7 @@ static void imx_ldb_encoder_prepare(struct drm_encoder *encoder)
>>> struct imx_ldb_channel *imx_ldb_ch = enc_to_imx_ldb_ch(encoder);
>>> struct imx_ldb *ldb = imx_ldb_ch->ldb;
>>> struct drm_display_mode *mode = &encoder->crtc->mode;
>>> + u32 pixel_fmt;
>>> unsigned long serial_clk;
>>> unsigned long di_clk = mode->clock * 1000;
>>> int mux = imx_drm_encoder_get_mux_id(imx_ldb_ch->imx_drm_encoder,
>>> @@ -194,8 +195,23 @@ static void imx_ldb_encoder_prepare(struct drm_encoder *encoder)
>>> imx_ldb_set_clock(ldb, mux, imx_ldb_ch->chno, serial_clk, di_clk);
>>> }
>>>
>>> + switch (imx_ldb_ch->chno) {
>>> + case 0:
>>> + pixel_fmt = (ldb->ldb_ctrl & LDB_DATA_WIDTH_CH0_24) ?
>>> + V4L2_PIX_FMT_RGB24 : V4L2_PIX_FMT_BGR666;
>>> + break;
>>> + case 1:
>>> + pixel_fmt = (ldb->ldb_ctrl & LDB_DATA_WIDTH_CH1_24) ?
>>> + V4L2_PIX_FMT_RGB24 : V4L2_PIX_FMT_BGR666;
>>> + break;
>>> + default:
>>> + dev_err(ldb->dev, "unable to config di%d panel format\n",
>>> + imx_ldb_ch->chno);
>>> + pixel_fmt = V4L2_PIX_FMT_RGB24;
>>> + }
>>> +
>>> imx_drm_crtc_panel_format_pins(encoder->crtc, DRM_MODE_ENCODER_LVDS,
>>> - V4L2_PIX_FMT_RGB24, 2, 3);
>>> + pixel_fmt, 2, 3);
>>
>> It seems the patch is based on an updated version of "staging: drm/imx:
>> Add LDB support"? The last one from Philipp [1] calls function
>> imx_drm_crtc_panel_format() rather than imx_drm_crtc_panel_format_pins()
>> there.
>>
>
> Grmbl! Yes. The last call should be
>
> imx_drm_crtc_panel_format(encoder->crtc, DRM_MODE_ENCODER_LVDS,
> V4L2_PIX_FMT_RGB24);
>
> like it already is in Philipps series.
> This patch sits on a topic branch, that (I think) Philipp didn't yet sent out.
> I will resent.
We should call
imx_drm_crtc_panel_format(encoder->crtc, DRM_MODE_ENCODER_LVDS, pixel_fmt);
Sorry, original patch was created before fixing imx_drm_crtc_panel_format.
>
> Thanks,
> Steffen
>
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
