On Fri, Jun 07, 2013 at 10:37:08AM +0200, Steffen Trumtrar wrote:
> From: Markus Niebel <Markus.Niebel@xxxxxx>
>
> Since 18 bit is supported as datawidth in device tree it should be
> supported in driver. Beside the LDB channel the IPU channel has also
> to be configured to use BGR666.
>
> Signed-off-by: Markus Niebel <Markus.Niebel@xxxxxx>
> Signed-off-by: Steffen Trumtrar <s.trumtrar@xxxxxxxxxxxxxx>
> ---
> This is based on the series: "staging: drm/imx: Add LDB support"
> by Philipp.
>
>
> drivers/staging/imx-drm/imx-ldb.c | 18 +++++++++++++++++-
> 1 file changed, 17 insertions(+), 1 deletion(-)
>
> diff --git a/drivers/staging/imx-drm/imx-ldb.c b/drivers/staging/imx-drm/imx-ldb.c
> index d8fc93c..84bf7d3 100644
> --- a/drivers/staging/imx-drm/imx-ldb.c
> +++ b/drivers/staging/imx-drm/imx-ldb.c
> @@ -179,6 +179,7 @@ static void imx_ldb_encoder_prepare(struct drm_encoder *encoder)
> struct imx_ldb_channel *imx_ldb_ch = enc_to_imx_ldb_ch(encoder);
> struct imx_ldb *ldb = imx_ldb_ch->ldb;
> struct drm_display_mode *mode = &encoder->crtc->mode;
> + u32 pixel_fmt;
> unsigned long serial_clk;
> unsigned long di_clk = mode->clock * 1000;
> int mux = imx_drm_encoder_get_mux_id(imx_ldb_ch->imx_drm_encoder,
> @@ -194,8 +195,23 @@ static void imx_ldb_encoder_prepare(struct drm_encoder *encoder)
> imx_ldb_set_clock(ldb, mux, imx_ldb_ch->chno, serial_clk, di_clk);
> }
>
> + switch (imx_ldb_ch->chno) {
> + case 0:
> + pixel_fmt = (ldb->ldb_ctrl & LDB_DATA_WIDTH_CH0_24) ?
> + V4L2_PIX_FMT_RGB24 : V4L2_PIX_FMT_BGR666;
> + break;
> + case 1:
> + pixel_fmt = (ldb->ldb_ctrl & LDB_DATA_WIDTH_CH1_24) ?
> + V4L2_PIX_FMT_RGB24 : V4L2_PIX_FMT_BGR666;
> + break;
> + default:
> + dev_err(ldb->dev, "unable to config di%d panel format\n",
> + imx_ldb_ch->chno);
> + pixel_fmt = V4L2_PIX_FMT_RGB24;
> + }
> +
> imx_drm_crtc_panel_format_pins(encoder->crtc, DRM_MODE_ENCODER_LVDS,
> - V4L2_PIX_FMT_RGB24, 2, 3);
> + pixel_fmt, 2, 3);
It seems the patch is based on an updated version of "staging: drm/imx:
Add LDB support"? The last one from Philipp [1] calls function
imx_drm_crtc_panel_format() rather than imx_drm_crtc_panel_format_pins()
there.
Shawn
[1] http://thread.gmane.org/gmane.linux.drivers.driver-project.devel/36836/focus=36834
> }
>
> static void imx_ldb_encoder_commit(struct drm_encoder *encoder)
> --
> 1.8.2.rc2
>
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
