This is a patch to the cb_pcidas.c file that fixes up a
printk warning found by the checkpatch.pl tool.
Converted printks to dev_<levels>..
Signed-off-by: Ravishankar Karkala Mallikarjunayya <ravishankar.km@xxxxxxxxxxxxxxx>
---
drivers/staging/comedi/drivers/cb_pcidas.c | 14 +++++++++-----
1 files changed, 9 insertions(+), 5 deletions(-)
diff --git a/drivers/staging/comedi/drivers/cb_pcidas.c b/drivers/staging/comedi/drivers/cb_pcidas.c
index 757c96a..7e4ffcf 100644
--- a/drivers/staging/comedi/drivers/cb_pcidas.c
+++ b/drivers/staging/comedi/drivers/cb_pcidas.c
@@ -855,7 +855,8 @@ static int ai_config_calibration_source(struct comedi_device *dev,
unsigned int source = data[1];
if (source >= num_calibration_sources) {
- printk("invalid calibration source: %i\n", source);
+ dev_err(dev->hw_dev, "invalid calibration source: %i\n",
+ source);
return -EINVAL;
}
@@ -1547,7 +1548,8 @@ static int cb_pcidas_ao_inttrig(struct comedi_device *dev,
spin_lock_irqsave(&dev->spinlock, flags);
devpriv->adc_fifo_bits |= DAEMIE | DAHFIE;
#ifdef CB_PCIDAS_DEBUG
- printk("comedi: adc_fifo_bits are 0x%x\n", devpriv->adc_fifo_bits);
+ dev_dbg(dev->hw_dev, "comedi: adc_fifo_bits are 0x%x\n",
+ devpriv->adc_fifo_bits);
#endif
/* enable and clear interrupts */
outw(devpriv->adc_fifo_bits | DAEMI | DAHFI,
@@ -1557,7 +1559,8 @@ static int cb_pcidas_ao_inttrig(struct comedi_device *dev,
devpriv->ao_control_bits |= DAC_START | DACEN | DAC_EMPTY;
outw(devpriv->ao_control_bits, devpriv->control_status + DAC_CSR);
#ifdef CB_PCIDAS_DEBUG
- printk("comedi: sent 0x%x to dac control\n", devpriv->ao_control_bits);
+ dev_dbg(dev->hw_dev, "comedi: sent 0x%x to dac control\n",
+ devpriv->ao_control_bits);
#endif
spin_unlock_irqrestore(&dev->spinlock, flags);
@@ -1585,8 +1588,9 @@ static irqreturn_t cb_pcidas_interrupt(int irq, void *d)
s5933_status = inl(devpriv->s5933_config + AMCC_OP_REG_INTCSR);
#ifdef CB_PCIDAS_DEBUG
- printk("intcsr 0x%x\n", s5933_status);
- printk("mbef 0x%x\n", inl(devpriv->s5933_config + AMCC_OP_REG_MBEF));
+ dev_dbg(dev->hw_dev, "intcsr 0x%x\n", s5933_status);
+ dev_dbg(dev->hw_dev, "mbef 0x%x\n",
+ inl(devpriv->s5933_config + AMCC_OP_REG_MBEF));
#endif
if ((INTCSR_INTR_ASSERTED & s5933_status) == 0)
--
1.7.0.4
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
