On Fri, May 13, 2011 at 03:46:56PM +0200, Piotr Kaczorek wrote: > I'm using vt6655 driver from 2.6.38 kernel for my wifi card. It's > set up as access point (using modified script from VIA's native > drivers - attached in package). Right there you are probably alone in doing this. Running the device as an access point is something that I doubt the code really was ever tested for at all. > I'd like to know if there is a possibility to run this card in > monitor mode? It would be best if I could run AP and monitor modes > at the same time (maybe on separate interfaces?). > > I also found a problem with sent packets. My setup is quite strange > - my AP doesn't give access to the internet but substitutes any > request with my page hosted on AP itself (kind of captive portal). > There is a dnsmasq set to provide DHCP and DNS pointing to hotspot > itself. All packets coming from eth1 are intercepted by iptables (-A > PREROUTING -i eth1 -p tcp -j DNAT --to-destination > 192.168.100.1:8180). On port 8180 i have nginx serving website. > The page is sent correct but images seem to break while being sent > (on mobile phones i can't see them in the browser or can see only > part of them, on windows however whole content is sent correctly). > I attach packet dumps from three devices i'm testing it on - > SonyEricsson P1i (Opera Mobile), BlackBerry Curve 8520 (their native > browser) and laptop with Window VIsta installed (FF4.0). Each > contains one request to some 'made up' url. You should be happey that you are even getting this to work at all :) And I think you are really on your own here, any patches that you could provide to resolve any of these issues would be greatly appreciated. good luck, greg k-h _______________________________________________ devel mailing list devel@xxxxxxxxxxxxxxxxxxxxxx http://driverdev.linuxdriverproject.org/mailman/listinfo/devel
