Re: [RFC PATCH] Add bridge driver to connect sensors to CIO2 device via software nodes on ACPI platforms

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Andy,

On Thu, Sep 17, 2020 at 03:45:14PM +0300, Andy Shevchenko wrote:
> On Thu, Sep 17, 2020 at 11:52:28AM +0100, Dan Scally wrote:
> > On 17/09/2020 11:33, Sakari Ailus wrote:
> > > a module and not enlarge everyone's kernel, and the initialisation would at
> > > the same time take place before the rest of what the CIO2 driver does in
> > > probe.
> > I thought of that as well, but wasn't sure which was preferable. I can
> > compress it into the CIO2 driver though sure.
> 
> Sakari, I tend to agree with Dan and have the board file separated from the
> driver and even framework.

And it'll be linked to the kernel binary then I suppose?

I don't have a strong opinion either way, just thought that this will
affect anyone using x86 machines, whether or not they have IPU3. I guess it
could be compiled in if the ipu3-cio2 driver is enabled?

-- 
Sakari Ailus
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel



[Index of Archives]     [Linux Driver Backports]     [DMA Engine]     [Linux GPIO]     [Linux SPI]     [Video for Linux]     [Linux USB Devel]     [Linux Coverity]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux