On Wed, Jul 29, 2020 at 11:12 AM Ankit Baluni <b18007@xxxxxxxxxxxxxxxxxxxxxxx> wrote: > > Added a missing comma and changed 'it it useful' to 'it is useful'. Reviewed-by: Andy Shevchenko <andy.shevchenko@xxxxxxxxx> > Signed-off-by: Ankit Baluni <b18007@xxxxxxxxxxxxxxxxxxxxxxx> > --- > Changes in -v2: > -Remove space before ':' in subject line. > > drivers/staging/iio/Documentation/overview.txt | 4 ++-- > 1 file changed, 2 insertions(+), 2 deletions(-) > > diff --git a/drivers/staging/iio/Documentation/overview.txt b/drivers/staging/iio/Documentation/overview.txt > index ebdc64f451d7..00409d5dab4e 100644 > --- a/drivers/staging/iio/Documentation/overview.txt > +++ b/drivers/staging/iio/Documentation/overview.txt > @@ -9,7 +9,7 @@ The aim is to fill the gap between the somewhat similar hwmon and > input subsystems. Hwmon is very much directed at low sample rate > sensors used in applications such as fan speed control and temperature > measurement. Input is, as its name suggests focused on input > -devices. In some cases there is considerable overlap between these and > +devices. In some cases, there is considerable overlap between these and > IIO. > > A typical device falling into this category would be connected via SPI > @@ -38,7 +38,7 @@ series and Analog Devices ADXL345 accelerometers. Each buffer supports > polling to establish when data is available. > > * Trigger and software buffer support. In many data analysis > -applications it it useful to be able to capture data based on some > +applications it is useful to be able to capture data based on some > external signal (trigger). These triggers might be a data ready > signal, a gpio line connected to some external system or an on > processor periodic interrupt. A single trigger may initialize data > -- > 2.25.1 > -- With Best Regards, Andy Shevchenko _______________________________________________ devel mailing list devel@xxxxxxxxxxxxxxxxxxxxxx http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
