On Wed, Jun 7, 2017 at 11:33 AM, Steve Longerbeam <slongerbeam@xxxxxxxxx> wrote:
> Enables the ADV7180 decoder sensor. The ADV7180 connects to the
> parallel-bus mux input on ipu1_csi0_mux.
>
> The ADV7180 power pin is via max7310_b port expander.
>
> Signed-off-by: Steve Longerbeam <steve_longerbeam@xxxxxxxxxx>
>
> - Use IRQ_TYPE_LEVEL_LOW instead of 0x8 for interrupt type for clarity.
> - For 8-bit parallel IPU1-CSI0 bus connection only data[12-19] are used.
>
> Signed-off-by: Tim Harvey <tharvey@xxxxxxxxxxxxx>
> ---
> arch/arm/boot/dts/imx6qdl-sabreauto.dtsi | 50 ++++++++++++++++++++++++++++++++
> 1 file changed, 50 insertions(+)
>
> diff --git a/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi b/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
> index 1212f82..c24af28 100644
> --- a/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
> +++ b/arch/arm/boot/dts/imx6qdl-sabreauto.dtsi
> @@ -124,6 +124,21 @@
> #size-cells = <0>;
> reg = <1>;
>
> + adv7180: camera@21 {
> + compatible = "adi,adv7180";
> + reg = <0x21>;
> + powerdown-gpios = <&max7310_b 2 GPIO_ACTIVE_LOW>;
> + interrupt-parent = <&gpio1>;
> + interrupts = <27 IRQ_TYPE_LEVEL_LOW>;
> +
> + port {
> + adv7180_to_ipu1_csi0_mux: endpoint {
> + remote-endpoint = <&ipu1_csi0_mux_from_parallel_sensor>;
> + bus-width = <8>;
> + };
> + };
> + };
> +
> max7310_a: gpio@30 {
> compatible = "maxim,max7310";
> reg = <0x30>;
> @@ -151,6 +166,25 @@
> };
> };
>
> +&ipu1_csi0_from_ipu1_csi0_mux {
> + bus-width = <8>;
> +};
> +
> +&ipu1_csi0_mux_from_parallel_sensor {
> + remote-endpoint = <&adv7180_to_ipu1_csi0_mux>;
> + bus-width = <8>;
> +};
> +
> +&ipu1_csi0 {
> + pinctrl-names = "default";
> + pinctrl-0 = <&pinctrl_ipu1_csi0>;
> +
> + /* enable frame interval monitor on this port */
> + fim {
> + status = "okay";
> + };
Steve,
You need to remove the fim node now that you've moved this to V4L2 controls.
Regards,
Tim
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/driverdev-devel
