Re: ARM IOMUX GPIO SETTING

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Wed, May 12, 2010 at 10:25:22AM +0530, snehajp wrote:
> Hi ,
> 
>   We are using i.mx 25 board which consists of arm9 controller.I need to
> convert the CMOS connector in the board to parallel port pins.We have to
> convert CMOS connector pins to GPIO pins using IOMUX configuration.Could
> any one help me to configure GPIO pins as parallel port pins and to set
> the base address.

Try asking this on the arm linux mailing list, that's the best place to
find people to help out with this.

good luck,

greg k-h
_______________________________________________
devel mailing list
devel@xxxxxxxxxxxxxxxxxxxxxx
http://driverdev.linuxdriverproject.org/mailman/listinfo/devel

[Index of Archives]     [Linux Driver Backports]     [DMA Engine]     [Linux GPIO]     [Linux SPI]     [Video for Linux]     [Linux USB Devel]     [Linux Coverity]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Yosemite Backpacking]
  Powered by Linux