Texas Instruments INA3221 is a triple-channel shunt and bus
voltage monitor. This patch adds a DT binding doc for it.
Signed-off-by: Nicolin Chen <nicoleotsuka@xxxxxxxxx>
---
Changelog
v4->v5:
* Replaced "input-id" with "reg" and added address-cells and size-cells
* Replaced "input-label" with "label"
* Replaced "shunt-resistor" with "shunt-resistor-micro-ohms"
v3->v4:
* Removed the attempt of putting labels in the node names
* Added a new optional label property in the child node
* Updated examples accordingly
v2->v3:
* Added a simple subject in the line 1
* Fixed the shunt resistor value in the example
v1->v2:
* Dropped channel name properties
* Added child node definitions.
* * Added shunt resistor property in the child node
* * Added status property to indicate connection status
* * Changed to use child node name as the label of input source
.../devicetree/bindings/hwmon/ina3221.txt | 49 +++++++++++++++++++
1 file changed, 49 insertions(+)
create mode 100644 Documentation/devicetree/bindings/hwmon/ina3221.txt
diff --git a/Documentation/devicetree/bindings/hwmon/ina3221.txt b/Documentation/devicetree/bindings/hwmon/ina3221.txt
new file mode 100644
index 000000000000..e17a897f4803
--- /dev/null
+++ b/Documentation/devicetree/bindings/hwmon/ina3221.txt
@@ -0,0 +1,49 @@
+Texas Instruments INA3221 Device Tree Bindings
+
+1) ina3221 node
+ Required properties:
+ - compatible: Must be "ti,ina3221"
+ - reg: I2C address
+
+ Optional properties:
+ = The node contains optional child nodes for three channels =
+ = Each child node describes the information of input source =
+
+ - #address-cells: Required only if a child node is present. Must be 1.
+ - #size-cells: Required only if a child node is present. Must be 0.
+
+ Example:
+
+ ina3221@40 {
+ compatible = "ti,ina3221";
+ reg = <0x40>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ [ child node definitions... ]
+ };
+
+2) child nodes
+ Required properties:
+ - reg: Must be 0, 1 or 2, corresponding to IN1, IN2 or IN3 port of INA3221
+
+ Optional properties:
+ - label: Name of the input source
+ - shunt-resistor-micro-ohms: Shunt resistor value in micro-Ohm
+ - status: Should be "disabled" if no input source
+
+ Example:
+
+ input@0 {
+ reg = <0x0>;
+ status = "disabled";
+ };
+ input@1 {
+ reg = <0x1>;
+ shunt-resistor-micro-ohms = <5000>;
+ };
+ input@2 {
+ reg = <0x2>;
+ label = "VDD_5V";
+ shunt-resistor-micro-ohms = <5000>;
+ };
--
2.17.1
