This driver supports the GPIO controller found in LSI ZEVIO SoCs.
It has been successfully tested on a TI nspire CX calculator.
Signed-off-by: Fabian Vogt <fabian@xxxxxxxxxxxxxx>
---
It took a while for me to make this patch.
School, other projects and some bugs which prevented testing
were time consuming.
This patch should resolve all issues, hopefully.
Changes to V5:
-Rewrote documentation
-Doesn't kfree devm_kzalloc'd memory
-Fixed multiline comments
-Got rid of unnecessary braces
-Converted two too complex macros to static inline functions
.../devicetree/bindings/gpio/gpio-zevio.txt | 17 ++
drivers/gpio/Kconfig | 6 +
drivers/gpio/Makefile | 1 +
drivers/gpio/gpio-zevio.c | 221 +++++++++++++++++++++
4 files changed, 245 insertions(+)
create mode 100644 Documentation/devicetree/bindings/gpio/gpio-zevio.txt
create mode 100644 drivers/gpio/gpio-zevio.c
diff --git a/Documentation/devicetree/bindings/gpio/gpio-zevio.txt b/Documentation/devicetree/bindings/gpio/gpio-zevio.txt
new file mode 100644
index 0000000..17bd9c8
--- /dev/null
+++ b/Documentation/devicetree/bindings/gpio/gpio-zevio.txt
@@ -0,0 +1,17 @@
+Zevio GPIO controller
+
+Required properties:
+- compatible: Should be "lsi,zevio-gpio"
+- reg: Address and length of the register set for the device
+- #gpio-cells: Should be two. The first cell is the pin number and the
+ second cell is used to specify optional parameters (currently unused).
+- gpio-controller: Marks the device node as a GPIO controller.
+
+Example:
+ gpio: gpio@90000000 {
+ compatible = "lsi,zevio-gpio";
+ reg = <0x90000000 0x1000>;
+ gpio-controller;
+ #gpio-cells = <2>;
+ };
+
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig
index 903f24d..c69b9e3 100644
--- a/drivers/gpio/Kconfig
+++ b/drivers/gpio/Kconfig
@@ -145,6 +145,12 @@ config GPIO_EP93XX
depends on ARCH_EP93XX
select GPIO_GENERIC
+config GPIO_ZEVIO
+ bool "LSI ZEVIO SoC memory mapped GPIOs"
+ depends on OF
+ help
+ Say yes here to support the GPIO controller in LSI ZEVIO SoCs.
+
config GPIO_MM_LANTIQ
bool "Lantiq Memory mapped GPIOs"
depends on LANTIQ && SOC_XWAY
diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile
index 5d50179..b845375 100644
--- a/drivers/gpio/Makefile
+++ b/drivers/gpio/Makefile
@@ -99,3 +99,4 @@ obj-$(CONFIG_GPIO_WM8350) += gpio-wm8350.o
obj-$(CONFIG_GPIO_WM8994) += gpio-wm8994.o
obj-$(CONFIG_GPIO_XILINX) += gpio-xilinx.o
obj-$(CONFIG_GPIO_XTENSA) += gpio-xtensa.o
+obj-$(CONFIG_GPIO_ZEVIO) += gpio-zevio.o
diff --git a/drivers/gpio/gpio-zevio.c b/drivers/gpio/gpio-zevio.c
new file mode 100644
index 0000000..9354c8e
--- /dev/null
+++ b/drivers/gpio/gpio-zevio.c
@@ -0,0 +1,221 @@
+/*
+ * GPIO controller in LSI ZEVIO SoCs.
+ *
+ * Author: Fabian Vogt <fabian@xxxxxxxxxxxxxx>
+ *
+ * This program is free software; you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2 as
+ * published by the Free Software Foundation.
+ */
+
+#include <linux/spinlock.h>
+#include <linux/errno.h>
+#include <linux/module.h>
+#include <linux/bitops.h>
+#include <linux/io.h>
+#include <linux/of_device.h>
+#include <linux/of_gpio.h>
+#include <linux/slab.h>
+#include <linux/gpio.h>
+
+/*
+ * Memory layout:
+ * This chip has four gpio sections, each controls 8 GPIOs.
+ * Bit 0 in section 0 is GPIO 0, bit 2 in section 1 is GPIO 10.
+ * Disclaimer: Reverse engineered!
+ * For more information refer to:
+ * http://hackspire.unsads.com/wiki/index.php/Memory-mapped_I/O_ports#90000000_-_General_Purpose_I.2FO_.28GPIO.29
+ *
+ * 0x00-0x3F: Section 0
+ * +0x00: Masked interrupt status (read-only)
+ * +0x04: R: Interrupt status W: Reset interrupt status
+ * +0x08: R: Interrupt mask W: Mask interrupt
+ * +0x0C: W: Unmask interrupt (write-only)
+ * +0x10: Direction: I/O=1/0
+ * +0x14: Output
+ * +0x18: Input (read-only)
+ * +0x20: R: Level interrupt W: Set as level interrupt
+ * 0x40-0x7F: Section 1
+ * 0x80-0xBF: Section 2
+ * 0xC0-0xFF: Section 3
+ */
+
+#define ZEVIO_GPIO_SECTION_SIZE 0x40
+
+/* Offsets to various registers */
+#define ZEVIO_GPIO_INT_MASKED_STATUS 0x00
+#define ZEVIO_GPIO_INT_STATUS 0x04
+#define ZEVIO_GPIO_INT_UNMASK 0x08
+#define ZEVIO_GPIO_INT_MASK 0x0C
+#define ZEVIO_GPIO_DIRECTION 0x10
+#define ZEVIO_GPIO_OUTPUT 0x14
+#define ZEVIO_GPIO_INPUT 0x18
+#define ZEVIO_GPIO_INT_STICKY 0x20
+
+#define to_zevio_gpio(chip) container_of(to_of_mm_gpio_chip(chip), \
+ struct zevio_gpio, chip)
+
+/* Bit number of GPIO in its section */
+#define ZEVIO_GPIO_BIT(gpio) (gpio&7)
+
+struct zevio_gpio {
+ spinlock_t lock;
+ struct of_mm_gpio_chip chip;
+};
+
+static inline u32 zevio_gpio_port_get(struct zevio_gpio *c, unsigned pin,
+ unsigned port_offset)
+{
+ unsigned section_offset = ((pin >> 3) & 3)*ZEVIO_GPIO_SECTION_SIZE;
+ return readl(IOMEM(c->chip.regs + section_offset + port_offset));
+}
+
+static inline void zevio_gpio_port_set(struct zevio_gpio *c, unsigned pin,
+ unsigned port_offset, u32 val)
+{
+ unsigned section_offset = ((pin >> 3) & 3)*ZEVIO_GPIO_SECTION_SIZE;
+ writel(val, IOMEM(c->chip.regs + section_offset + port_offset));
+}
+
+/* Functions for struct gpio_chip */
+static int zevio_gpio_get(struct gpio_chip *chip, unsigned pin)
+{
+ struct zevio_gpio *controller = to_zevio_gpio(chip);
+
+ /* Only reading allowed, so no spinlock needed */
+ u32 val = zevio_gpio_port_get(controller, pin, ZEVIO_GPIO_INPUT);
+
+ return (val >> ZEVIO_GPIO_BIT(pin)) & 0x1;
+}
+
+static void zevio_gpio_set(struct gpio_chip *chip, unsigned pin, int value)
+{
+ struct zevio_gpio *controller = to_zevio_gpio(chip);
+ u32 val;
+
+ spin_lock(&controller->lock);
+ val = zevio_gpio_port_get(controller, pin, ZEVIO_GPIO_OUTPUT);
+ if (value)
+ val |= BIT(ZEVIO_GPIO_BIT(pin));
+ else
+ val &= ~BIT(ZEVIO_GPIO_BIT(pin));
+
+ zevio_gpio_port_set(controller, pin, ZEVIO_GPIO_OUTPUT, val);
+ spin_unlock(&controller->lock);
+}
+
+static int zevio_gpio_direction_input(struct gpio_chip *chip, unsigned pin)
+{
+ struct zevio_gpio *controller = to_zevio_gpio(chip);
+ u32 val;
+
+ spin_lock(&controller->lock);
+
+ val = zevio_gpio_port_get(controller, pin, ZEVIO_GPIO_DIRECTION);
+ val |= BIT(ZEVIO_GPIO_BIT(pin));
+ zevio_gpio_port_set(controller, pin, ZEVIO_GPIO_DIRECTION, val);
+
+ spin_unlock(&controller->lock);
+
+ return 0;
+}
+
+static int zevio_gpio_direction_output(struct gpio_chip *chip,
+ unsigned pin, int value)
+{
+ struct zevio_gpio *controller = to_zevio_gpio(chip);
+ u32 val;
+
+ spin_lock(&controller->lock);
+ val = zevio_gpio_port_get(controller, pin, ZEVIO_GPIO_OUTPUT);
+ if (value)
+ val |= BIT(ZEVIO_GPIO_BIT(pin));
+ else
+ val &= ~BIT(ZEVIO_GPIO_BIT(pin));
+
+ zevio_gpio_port_set(controller, pin, ZEVIO_GPIO_OUTPUT, val);
+ val = zevio_gpio_port_get(controller, pin, ZEVIO_GPIO_DIRECTION);
+ val &= ~BIT(ZEVIO_GPIO_BIT(pin));
+ zevio_gpio_port_set(controller, pin, ZEVIO_GPIO_DIRECTION, val);
+
+ spin_unlock(&controller->lock);
+
+ return 0;
+}
+
+static int zevio_gpio_to_irq(struct gpio_chip *chip, unsigned pin)
+{
+ /*
+ * TODO: Implement IRQs.
+ * Not implemented yet due to weird lockups
+ */
+
+ return -ENXIO;
+}
+
+static struct gpio_chip zevio_gpio_chip = {
+ .direction_input = zevio_gpio_direction_input,
+ .direction_output = zevio_gpio_direction_output,
+ .set = zevio_gpio_set,
+ .get = zevio_gpio_get,
+ .to_irq = zevio_gpio_to_irq,
+ .base = 0,
+ .owner = THIS_MODULE,
+ .ngpio = 32,
+ .of_gpio_n_cells = 2,
+};
+
+/* Initialization */
+static int zevio_gpio_probe(struct platform_device *pdev)
+{
+ struct zevio_gpio *controller;
+ int status, i;
+
+ controller = devm_kzalloc(&pdev->dev, sizeof(*controller), GFP_KERNEL);
+ if (!controller) {
+ dev_err(&pdev->dev, "not enough free memory\n");
+ return -ENOMEM;
+ }
+
+ /* Copy our reference */
+ controller->chip.gc = zevio_gpio_chip;
+ controller->chip.gc.dev = &pdev->dev;
+
+ status = of_mm_gpiochip_add(pdev->dev.of_node, &(controller->chip));
+ if (status) {
+ dev_err(&pdev->dev, "failed to add gpiochip: %d\n", status);
+ return status;
+ }
+
+ spin_lock_init(&controller->lock);
+
+ /* Disable interrupts, they only cause errors */
+ for (i = 0; i < controller->chip.gc.ngpio; i += 8)
+ zevio_gpio_port_set(controller, i, ZEVIO_GPIO_INT_MASK, 0xFF);
+
+ dev_dbg(controller->chip.gc.dev, "ZEVIO GPIO controller set up!\n");
+
+ return 0;
+}
+
+static struct of_device_id zevio_gpio_of_match[] = {
+ { .compatible = "lsi,zevio-gpio", },
+ { },
+};
+
+MODULE_DEVICE_TABLE(of, zevio_gpio_of_match);
+
+static struct platform_driver zevio_gpio_driver = {
+ .driver = {
+ .name = "gpio-zevio",
+ .owner = THIS_MODULE,
+ .of_match_table = of_match_ptr(zevio_gpio_of_match),
+ },
+ .probe = zevio_gpio_probe,
+};
+
+module_platform_driver(zevio_gpio_driver);
+
+MODULE_LICENSE("GPL");
+MODULE_AUTHOR("Fabian Vogt <fabian@xxxxxxxxxxxxxx>");
+MODULE_DESCRIPTION("LSI ZEVIO SoC GPIO driver");
--
1.8.1.4
--
To unsubscribe from this list: send the line "unsubscribe linux-doc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
