On Thu, 24 Oct 2024 15:52:23 +0100 Simon Horman <horms@xxxxxxxxxx> wrote: > On Wed, Oct 23, 2024 at 04:15:58PM +0200, Kory Maincent wrote: > > ETHTOOL_MSG_PHY_GET/GET_REPLY/NTF is missing in the ethtool message list. > > Add it to the ethool netlink documentation. > > > > Signed-off-by: Kory Maincent <kory.maincent@xxxxxxxxxxx> > > --- > > Documentation/networking/ethtool-netlink.rst | 3 +++ > > 1 file changed, 3 insertions(+) > > > > diff --git a/Documentation/networking/ethtool-netlink.rst > > b/Documentation/networking/ethtool-netlink.rst index > > 295563e91082..70ecc3821007 100644 --- > > a/Documentation/networking/ethtool-netlink.rst +++ > > b/Documentation/networking/ethtool-netlink.rst @@ -236,6 +236,7 @@ > > Userspace to kernel: ``ETHTOOL_MSG_MM_GET`` get MAC merge > > layer state ``ETHTOOL_MSG_MM_SET`` set MAC merge layer > > parameters ``ETHTOOL_MSG_MODULE_FW_FLASH_ACT`` flash transceiver module > > firmware > > + ``ETHTOOL_MSG_PHY_GET`` get Ethernet PHY information > > ===================================== ================================= > > > > Kernel to userspace: > > @@ -283,6 +284,8 @@ Kernel to userspace: > > ``ETHTOOL_MSG_PLCA_NTF`` PLCA RS parameters > > ``ETHTOOL_MSG_MM_GET_REPLY`` MAC merge layer status > > ``ETHTOOL_MSG_MODULE_FW_FLASH_NTF`` transceiver module flash updates > > + ``ETHTOOL_MSG_PHY_GET_REPLY`` Ethernet PHY information > > + ``ETHTOOL_MSG_PHY_NTF`` Ethernet PHY information > > I wonder if ETHTOOL_MSG_PHY_NTF should be removed. > It doesn't seem to be used anywhere. We can't, as it is in the ethtool UAPI. Also I believe Maxime will use it on later patch series. Maxime, you confirm? Regards, -- Köry Maincent, Bootlin Embedded Linux and kernel engineering https://bootlin.com