On Wed, Oct 23, 2024 at 04:15:58PM +0200, Kory Maincent wrote: > ETHTOOL_MSG_PHY_GET/GET_REPLY/NTF is missing in the ethtool message list. > Add it to the ethool netlink documentation. > > Signed-off-by: Kory Maincent <kory.maincent@xxxxxxxxxxx> > --- > Documentation/networking/ethtool-netlink.rst | 3 +++ > 1 file changed, 3 insertions(+) > > diff --git a/Documentation/networking/ethtool-netlink.rst b/Documentation/networking/ethtool-netlink.rst > index 295563e91082..70ecc3821007 100644 > --- a/Documentation/networking/ethtool-netlink.rst > +++ b/Documentation/networking/ethtool-netlink.rst > @@ -236,6 +236,7 @@ Userspace to kernel: > ``ETHTOOL_MSG_MM_GET`` get MAC merge layer state > ``ETHTOOL_MSG_MM_SET`` set MAC merge layer parameters > ``ETHTOOL_MSG_MODULE_FW_FLASH_ACT`` flash transceiver module firmware > + ``ETHTOOL_MSG_PHY_GET`` get Ethernet PHY information > ===================================== ================================= > > Kernel to userspace: > @@ -283,6 +284,8 @@ Kernel to userspace: > ``ETHTOOL_MSG_PLCA_NTF`` PLCA RS parameters > ``ETHTOOL_MSG_MM_GET_REPLY`` MAC merge layer status > ``ETHTOOL_MSG_MODULE_FW_FLASH_NTF`` transceiver module flash updates > + ``ETHTOOL_MSG_PHY_GET_REPLY`` Ethernet PHY information > + ``ETHTOOL_MSG_PHY_NTF`` Ethernet PHY information I wonder if ETHTOOL_MSG_PHY_NTF should be removed. It doesn't seem to be used anywhere. > ======================================== ================================= > > ``GET`` requests are sent by userspace applications to retrieve device > -- > 2.34.1 > >