On Wed, Oct 23, 2013 at 02:31:56PM +0800, Shawn Guo wrote: > On Tue, Oct 22, 2013 at 01:58:44PM +0800, Peter Chen wrote: > > This property is used to disconnect line between USB PHY and > > USB controller. > > > > Signed-off-by: Peter Chen <peter.chen@xxxxxxxxxxxxx> > > --- > > Documentation/devicetree/bindings/usb/mxs-phy.txt | 4 ++++ > > 1 files changed, 4 insertions(+), 0 deletions(-) > > > > diff --git a/Documentation/devicetree/bindings/usb/mxs-phy.txt b/Documentation/devicetree/bindings/usb/mxs-phy.txt > > index 5837963..356c9b6 100644 > > --- a/Documentation/devicetree/bindings/usb/mxs-phy.txt > > +++ b/Documentation/devicetree/bindings/usb/mxs-phy.txt > > @@ -9,6 +9,9 @@ mxs PHY verions. > > - reg: Should contain registers location and length > > - interrupts: Should contain phy interrupt > > - fsl,anatop: phandle for anatop register, it is only for mx6 SoC serial > > +- disconnect-line-without-vbus: needs to disconnect > > +connection between USB PHY and controller, it can avoid > > +unexpected wakeup interrupt when the PHY is out of power > > If it's a mxs-phy specific property, we may need to have vendor prefix > 'fsl,' for it. It is mx6 version mxs-phy specific, I will add prefix "imx6" > > I see you set the property in imx6qdl.dtsi. Is it true that we should > always set it for imx6q/dl? If yes, why cannot we have the driver to > force it for imx6q type of phy. If no, where do we need to set it and > where not? > Yes, it is needed for current imx6dq, imx6dl, and imx6sl SoC. -- Best Regards, Peter Chen -- To unsubscribe from this list: send the line "unsubscribe linux-doc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
