Re: [PATCH V4 1/3] mfd: add support for ams AS3722 PMIC

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 10/02/2013 09:50 AM, Laxman Dewangan wrote:
> The ams AS3722 is a compact system PMU suitable for mobile phones,
> tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
> controller, 11 LDOs, RTC, automatic battery, temperature and
> over-current monitoring, 8 GPIOs, ADC and a watchdog.

> diff --git a/Documentation/devicetree/bindings/mfd/as3722.txt b/Documentation/devicetree/bindings/mfd/as3722.txt

> +  The first cell is the IRQ number.

Which IRQ number exist? Perhaps the IRQ IDs match some specific HW register?

> +Pinmux and GPIO:

> +- pinctrl-names: A pinctrl state named "default" must be defined, using the
> +		bindings in pinctrl/pinctrl-binding.txt.

Why is the DT required to define a default state? If the board doesn't
need to set up any pinctrl settings, surely it shouldn't have to define
the default state.

> +- pinctrl[0...n]: Nodes for pin control to represents state 0 to state n.

These aren't nodes. Those are properties that contain phandles that
refer to nodes.

> +	Each of these nodes contains different subnodes to represents
> +	some desired configuration for a list of pins. This configuration can
> +	include the mux function to select on those pin(s), and various pin
> +	configuration parameters, such as pull-up, open drain.

What contains "these nodes"?

> +
> +Each subnode have following properties:
> +Required properties:
> +	pins: List of pins. Valid options for pins properties are
> +		gpio0, gpio1, gpio2, gpio3, gpio4, gpio5, gpio6, gpio7
> +
> +Optional properties:
> +	Optional properties are

Why repeat that?

> +		function, bias-disable, bias-pull-up, bias-pull-down,
> +		bias-high-impedance, drive-open-drain.
> +
> +		Valid options for funtion properties are:

s/funtion/function/

I would say "values" not "options", as I think I pointed out before, but
I supopse I don't care.

> +Optional sub nodes:

The following might make it clear where these optional nodes sit:

Optional sub nodes of "regulators":
-----------------------------------

> +	Additional custom properties  are listed below.

Required or optional?

--
To unsubscribe from this list: send the line "unsubscribe linux-doc" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at  http://vger.kernel.org/majordomo-info.html




[Index of Archives]     [Kernel Newbies]     [Security]     [Netfilter]     [Bugtraq]     [Linux FS]     [Yosemite Forum]     [MIPS Linux]     [ARM Linux]     [Linux Security]     [Linux RAID]     [Samba]     [Video 4 Linux]     [Device Mapper]     [Linux Resources]

  Powered by Linux