Wed, Jun 21, 2023 at 02:29:59PM CEST, jiri@xxxxxxxxxxx wrote:
>Mon, Jun 19, 2023 at 10:34:12PM CEST, arkadiusz.kubalewski@xxxxxxxxx wrote:
>>>From: Jiri Pirko <jiri@xxxxxxxxxxx>
>>>Sent: Saturday, June 10, 2023 6:37 PM
>>>
>>>Fri, Jun 09, 2023 at 02:18:51PM CEST, arkadiusz.kubalewski@xxxxxxxxx wrote:
>>>
>>>[...]
>>>
>>>
>>>>+static int ice_dpll_mode_get(const struct dpll_device *dpll, void *priv,
>>>>+ enum dpll_mode *mode,
>>>>+ struct netlink_ext_ack *extack)
>>>>+{
>>>>+ *mode = DPLL_MODE_AUTOMATIC;
>>>
>>>I don't understand how the automatic mode could work with SyncE. The
>>>There is one pin exposed for one netdev. The SyncE daemon should select
>>>exacly one pin. How do you achieve that?
>>>Is is by setting DPLL_PIN_STATE_SELECTABLE on the pin-netdev you want to
>>>select and DPLL_PIN_STATE_DISCONNECTED on the rest?
>>>
>>>
>>>[...]
>>
>>AUTOMATIC mode autoselects highest priority valid signal.
>>As you have pointed out, for SyncE selection, the user must be able to manually
>>select a pin state to enable recovery of signal from particular port.
>>
>>In "ice" case there are 2 pins for network PHY clock signal recovery, and both
>>are parent pins (MUX-type). There are also 4 pins assigned to netdevs (one per
>>port). Thus passing a signal from PHY to the pin is done through the MUX-pin,
>>by selecting proper state on pin-parent pair (where parent pins is highest prio
>>pin on dpll).
>
>Could you show me some examples please?
Arkadiusz, could you please reply to this?
Thanks!
>
>
>>
>>Thank you!
>>Arkadiusz
