Thanks for the comments. On 25/06/13 14:17, Thomas Gleixner wrote: > On Tue, 25 Jun 2013, Srinivas KANDAGATLA wrote: >> If its not too late can this patch be considered for 3.11 via clocksource tree? > > Sure. No worry, though I noticed a little detail when reading through it > again. See below. > >> +/** >> + * To ensure that updates to comparator value register do not set the >> + * Interrupt Status Register proceed as follows: >> + * 1. Clear the Comp Enable bit in the Timer Control Register. >> + * 2. Write the lower 32-bit Comparator Value Register. >> + * 3. Write the upper 32-bit Comparator Value Register. >> + * 4. Set the Comp Enable bit and, if necessary, the IRQ enable bit. >> + */ >> +static void gt_compare_set(unsigned long delta, int periodic) >> +{ >> + u64 counter = gt_counter_read(); >> + unsigned long ctrl = readl(gt_base + GT_CONTROL); > > Why are you reading the control register back over and over? All you > need to preserve is the GT_CONTROL_TIMER_ENABLE bit. So you can spare > that read out and just do > > ctrl = GT_CONTROL_TIMER_ENABLE; > writel(ctrl, gt_base + GT_CONTROL); Logically you are right we could do as you suggested, However its not implicit that which bits are going to be cleared. Its more to do with readability of the code. If you still insist I can change it. > >> +static irqreturn_t gt_clockevent_interrupt(int irq, void *dev_id) >> +{ >> + struct clock_event_device *evt = dev_id; >> + >> + if (readl_relaxed(gt_base + GT_INT_STATUS) & >> + GT_INT_STATUS_EVENT_FLAG) { > > If you negate the check and return IRQ_NONE, you save one indent level > for the real code. > Am ok either way, I will do it in the next version. >> + /** >> + * ERRATA 740657( Global Timer can send 2 interrupts for >> + * the same event in single-shot mode) >> + * Workaround: >> + * Either disable single-shot mode. >> + * Or >> + * Modify the Interrupt Handler to avoid the >> + * offending sequence. This is achieved by clearing >> + * the Global Timer flag _after_ having incremented >> + * the Comparator register value to a higher value. >> + */ >> + if (!(readl_relaxed(gt_base + GT_CONTROL) & >> + GT_CONTROL_AUTO_INC)) > > Again, no need to read from the hardware. > > if (evt->mode == CLOCK_EVT_MODE_ONESHOT) Yes, we can get it from evt->mode. I will do it in next version. > > tells you what you need to know. > > Thanks, > > tglx > > -- To unsubscribe from this list: send the line "unsubscribe linux-doc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html