On 24/06/13 16:04, Linus Walleij wrote: > On Thu, Jun 20, 2013 at 11:26 AM, James Hogan <james.hogan@xxxxxxxxxx> wrote: > >> Add a pin control driver for the main pins on the TZ1090 SoC. This >> doesn't include the low-power pins as they're controlled separately via >> the Powerdown Controller (PDC) registers. >> >> Signed-off-by: James Hogan <james.hogan@xxxxxxxxxx> >> Cc: Grant Likely <grant.likely@xxxxxxxxxx> >> Cc: Rob Herring <rob.herring@xxxxxxxxxxx> >> Cc: Rob Landley <rob@xxxxxxxxxxx> >> Cc: Linus Walleij <linus.walleij@xxxxxxxxxx> >> Cc: linux-doc@xxxxxxxxxxxxxxx >> Cc: devicetree-discuss@xxxxxxxxxxxxxxxx >> --- >> Changes in v3: >> - separated from irq-imgpdc and removed arch/metag changes to allow >> these patches to go upstream separately via the pinctrl[/gpio] trees >> (particularly the pinctrl drivers depend on the new pinconf DT >> bindings). >> - some s/unsigned/unsigned int/. >> - some s/unsigned int/bool/ and use of BIT(). >> - pinctrl-tz1090*: switch to generic pinconfig DT bindings and >> pinconf_generic_dump_config. >> - pinctrl-tz1090*: use tz1090, prefix for pins and function in DT >> bindings. >> - pinctrl-tz1090*: make internal functions static. >> - pinctrl-tz1090*: move initcall from postcore to arch. > > Thanks James, patch applied. > > Also thanks for helping out in getting the generic pinconf > in place for some three different drivers for this merge window, > this was very good for pinctrl at large. Thanks Linus, and no problem! Cheers James -- To unsubscribe from this list: send the line "unsubscribe linux-doc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
