On 02/26/13 15:10, Nishanth Menon wrote: > On 14:43-20130226, Randy Dunlap wrote: >> On 02/26/13 09:37, Nishanth Menon wrote: > [..] >>> >>> 1. Introduction >>> =============== >>> +1.1 What is an Operating Performance Point (OPP)? >>> + >>> Complex SoCs of today consists of a multiple sub-modules working in conjunction. >>> In an operational system executing varied use cases, not all modules in the SoC >>> need to function at their highest performing frequency all the time. To >>> facilitate this, sub-modules in a SoC are grouped into domains, allowing some >>> domains to run at lower voltage and frequency while other domains are loaded >>> -more. The set of discrete tuples consisting of frequency and voltage pairs that >>> +more. >> >> huh??? > I split the definition line to it's own paragraph below. But, I think > you intend to say we could improve better the remaining paragraph. > Could you elaborate your thoughts? "while other domains are loaded more." Some people probably understand that OK; I dunno. I would rather see it written out more verbosely, e.g.: "while other domains run at voltage/frequency pairs that are higher." but partly I was confused by the diff(1) lines. my bad :( >>> + >>> +The set of discrete tuples consisting of frequency and voltage pairs that >>> the device will support per domain are called Operating Performance Points or >>> OPPs. >>> >>> +As an example: >>> +Let us consider an MPU device which supports the following: >>> +{300MHz at minimum voltage of 1V}, {800MHz at minimum voltage of 1.2V}, >>> +{1GHz at minimum voltage of 1.3V} >>> + >>> +We can represent these as three OPPs as the following {Hz, uV} tuples: >>> +{300000000, 1000000} >>> +{600000000, 1200000} >> 800000000 >> >>> +{100000000, 1300000} >> 1000000000 ?? > Thanks for catching it. will fix it in next rev. > -- ~Randy -- To unsubscribe from this list: send the line "unsubscribe linux-doc" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html