Lothar, Thanks for your reply. I checked the output using netstat and it does match to 0.0.0.0:* Infact when i do telnet 192.168.1.2 512, i do get a reply but the reply is "Where are you?" followed by connection lost. Saurabh
On 8/15/06, Lothar Braun <mail@xxxxxxxxxx> wrote: > Hi, > > On Tuesday 15 August 2006 12:04, jassduec@xxxxxxxxx wrote: > > I can also do rlogin/rsh between the two machines using > > the private IP addresses (i.e. 1000mbps interfaces). However when i > > try to rexec between the private IP addresses, i get an error that > > "Where are you?" and connection lost. Why is it that i can do rexec > > between the two machines using the 100mbps interfaces with static > > public IP addresses but cannot do so using the private IP addresses. > > An explanation for this is that rlogin/rsh use port 513 while rexec works on > port 512. It is therefore possible, that rsh/rlogin and rexec work with > different configurations. > > I suppose that your inet-deamon listens on all interfaces for rlogin/rsh, > but > only on your public 100Mbit interface for rexec. > You can check this via > > netstat -tulpen | grep ":512" > > This will give you the address range from which your rexecd will accept > connections from. If this doesn't match 0.0.0.0:* then you'll have to check > your rexecds configuration. > > Best regards, > Lothar > >
- To unsubscribe from this list: send the line "unsubscribe linux-config" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
