Am Thu, Feb 13, 2025 at 08:07:22PM +0000 schrieb Conor Dooley: > On Wed, Feb 12, 2025 at 08:52:04PM +0100, Dimitri Fedrau wrote: > > Am Tue, Feb 11, 2025 at 04:38:48PM +0000 schrieb Conor Dooley: > > > On Tue, Feb 11, 2025 at 02:12:33PM +0100, Dimitri Fedrau via B4 Relay wrote: > > > > From: Dimitri Fedrau <dimitri.fedrau@xxxxxxxxxxxx> > > > > > > > > Currently the flexcan driver does not support adding PHYs. Add the > > > > capability to ensure that the PHY is in operational state when the link > > > > is set to an "up" state. > > > > > > > > Signed-off-by: Dimitri Fedrau <dimitri.fedrau@xxxxxxxxxxxx> > > > > --- > > > > Documentation/devicetree/bindings/net/can/fsl,flexcan.yaml | 3 +++ > > > > 1 file changed, 3 insertions(+) > > > > > > > > diff --git a/Documentation/devicetree/bindings/net/can/fsl,flexcan.yaml b/Documentation/devicetree/bindings/net/can/fsl,flexcan.yaml > > > > index 97dd1a7c5ed26bb7f1b2f78c326d91e2c299938a..397957569588a61111a313cf9107e29dacc9e667 100644 > > > > --- a/Documentation/devicetree/bindings/net/can/fsl,flexcan.yaml > > > > +++ b/Documentation/devicetree/bindings/net/can/fsl,flexcan.yaml > > > > @@ -70,6 +70,9 @@ properties: > > > > xceiver-supply: > > > > description: Regulator that powers the CAN transceiver. > > > > > > > > + phys: > > > > + maxItems: 1 > > > > > > Can all devices in this binding support external phy? Are all devices > > > limited to a single external phy? > > > > > As far as I know, these devices are controllers without integrated PHY. > > So they need a single external PHY. Transceivers can be very simple like > > xceiver-supply in the binding, but I want to use "ti,tcan1043" in > > drivers/phy/phy-can-transceiver. > > I'm not quite following, do all of these devices need to have an > external phy but the property did not exist until now? How did any of > them work, if that's the case? The property xceiver-supply is used to describe connected transceiver which do only rely on corresponding regulator configuration. For example here: https://elixir.bootlin.com/linux/v6.14-rc2/source/arch/arm/boot/dts/nxp/imx/imx6qdl-sabreauto.dtsi#L105 But I want to enable support for these: https://elixir.bootlin.com/linux/v6.14-rc2/source/Documentation/devicetree/bindings/phy/ti,tcan104x-can.yaml Best regards, Dimitri Fedrau
