Re: [PATCH v4 0/4] can: rcar_canfd: Add support for V3U flavor

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On 09.03.2022 17:26:05, Ulrich Hecht wrote:
> This adds CANFD support for V3U (R8A779A0) SoCs. The V3U's IP supports up
> to eight channels and has some other minor differences to the Gen3 variety:
> 
> - changes to some register offsets and layouts
> - absence of "classic CAN" registers, both modes are handled through the
>   CANFD register set
> 
> This patch set tries to accommodate these changes in a minimally intrusive
> way.
> 
> This revision tries to address the remaining style issues raised by
> reviewers. Thanks to Vincent, Marc and Simon for their reviews and
> suggestions.
> 
> It has been successfully tested remotely on a V3U Falcon board, but only
> with channels 0 and 1. We were not able to get higher channels to work in
> both directions yet. It is not currently clear if this is an issue with the
> driver, the board or the silicon, but the BSP vendor driver only works with
> channels 0 and 1 as well, so my bet is on one of the latter. For this
> reason, this series only enables known-working channels 0 and 1 on Falcon.

Should I take the whole series via linux-can/next?

Marc

-- 
Pengutronix e.K.                 | Marc Kleine-Budde           |
Embedded Linux                   | https://www.pengutronix.de  |
Vertretung West/Dortmund         | Phone: +49-231-2826-924     |
Amtsgericht Hildesheim, HRA 2686 | Fax:   +49-5121-206917-5555 |

Attachment: signature.asc
Description: PGP signature


[Index of Archives]     [Automotive Discussions]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux]     [Linux OMAP]     [Linux MIPS]     [eCos]     [Asterisk Internet PBX]     [Linux API]     [CAN Bus]

  Powered by Linux