Signed-off-by: Marc Kleine-Budde <mkl@xxxxxxxxxxxxxx> --- drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can.c | 10 +++++----- drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_fifo.c | 4 ++-- drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_int.c | 2 +- drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_rx.c | 2 +- 4 files changed, 9 insertions(+), 9 deletions(-) diff --git a/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can.c b/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can.c index e28aad2b6ac8..8b81811abd9a 100644 --- a/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can.c +++ b/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can.c @@ -63,23 +63,23 @@ #include <uapi/linux/can/netlink.h> /* module parameters */ -unsigned int bw_sharing_log2bits; +static unsigned int bw_sharing_log2bits; module_param(bw_sharing_log2bits, uint, 0664); MODULE_PARM_DESC(bw_sharing_log2bits, "Delay between 2 transmissions in number of arbitration bit times\n"); -bool enable_edge_filter; +static bool enable_edge_filter; module_param(enable_edge_filter, bool, 0664); MODULE_PARM_DESC(enable_edge_filter, "Enable ISO11898-1:2015 edge_filtering"); -unsigned int tdc_mode = 2; +static unsigned int tdc_mode = 2; module_param(tdc_mode, uint, 0664); MODULE_PARM_DESC(tdc_mode, "Transmitter Delay Mode - 0 = disabled, 1 = fixed, 2 = auto\n"); -unsigned int tdc_value; +static unsigned int tdc_value; module_param(tdc_value, uint, 0664); MODULE_PARM_DESC(tdc_value, "Transmission Delay Value - range: [0:63] SCLK"); -int tdc_offset = 64; /* outside of range to use computed values */ +static int tdc_offset = 64; /* outside of range to use computed values */ module_param(tdc_offset, int, 0664); MODULE_PARM_DESC(tdc_offset, "Transmission Delay offset - range: [-64:63] SCLK"); diff --git a/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_fifo.c b/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_fifo.c index bf94120f2609..7204864ee07e 100644 --- a/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_fifo.c +++ b/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_fifo.c @@ -20,11 +20,11 @@ * so we allow to control them via module parameters (that can changed * in /sys if needed) - theses are only needed during setup if the can_device */ -unsigned int tx_fifos; +static unsigned int tx_fifos; module_param(tx_fifos, uint, 0664); MODULE_PARM_DESC(tx_fifos, "Number of tx-fifos to configure\n"); -bool three_shot; +static bool three_shot; module_param(three_shot, bool, 0664); MODULE_PARM_DESC(three_shot, "Use 3 shots when one-shot is requested"); diff --git a/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_int.c b/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_int.c index 5a97c69fb37e..f159267e7f6c 100644 --- a/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_int.c +++ b/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_int.c @@ -27,7 +27,7 @@ #include "mcp25xxfd_cmd.h" #include "mcp25xxfd_ecc.h" -unsigned int reschedule_int_thread_after = 4; +static unsigned int reschedule_int_thread_after = 4; module_param(reschedule_int_thread_after, uint, 0664); MODULE_PARM_DESC(reschedule_int_thread_after, "Reschedule the interrupt thread after this many loops\n"); diff --git a/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_rx.c b/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_rx.c index 11bf12461e58..5d3141d6b2ce 100644 --- a/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_rx.c +++ b/drivers/net/can/spi/mcp25xxfd/mcp25xxfd_can_rx.c @@ -26,7 +26,7 @@ #include "mcp25xxfd_can_rx.h" /* module parameters */ -unsigned int rx_prefetch_bytes = -1; +static unsigned int rx_prefetch_bytes = -1; module_param(rx_prefetch_bytes, uint, 0664); MODULE_PARM_DESC(rx_prefetch_bytes, "number of bytes to blindly prefetch when reading a rx-fifo"); -- 2.20.1
