Wolfgang On 1/18/19 12:56 AM, Wolfgang Grandegger wrote: > Hello Dan, > > Am 17.01.19 um 21:08 schrieb Dan Murphy: >> Wolfgang >> >> On 1/17/19 2:05 PM, Dan Murphy wrote: >>> Create a m_can platform framework that peripherial >>> devices can register to and use common code and register sets. >>> The peripherial devices may provide read/write and configuration >>> support of the IP. >>> >>> Signed-off-by: Dan Murphy <dmurphy@xxxxxx> >>> --- >>> drivers/net/can/m_can/m_can.c | 6 + >>> drivers/net/can/m_can/m_can_platform.c | 209 +++++++++++++++++++++++++ >>> drivers/net/can/m_can/m_can_platform.h | 163 +++++++++++++++++++ >>> 3 files changed, 378 insertions(+) >>> create mode 100644 drivers/net/can/m_can/m_can_platform.c >>> create mode 100644 drivers/net/can/m_can/m_can_platform.h >>> > > ... snip ... > >> This patch set is working for the TCAN and at least boots on io-mapped devices. >> We have a couple of customers who are looking at using this implementation and we would like to >> start moving this patch set along in the review. >> >> I did not put a change log in here as there have been no comments for the last 3 patch sets I sent. >> >> This v4 squashes a few bugs I found during testing across all the files. > > OK, after a very busy week I will try to find time for the review... > finally. > Thanks. I anticipate a v5 as we debug the io mapped code and continue to test the TCAN code. Dan > Thanks, > > Wolfgang. > -- ------------------ Dan Murphy
