Add the MGMT quality report command and event in doc/mgmt-api.txt. --- Changes in v5: - Use Quality_Report instead of Action in mgmt-api.txt. - Modify the description of Set Quality Report Command. Changes in v4: - Use "Quality Report Event" without the prefix "Bluetooth" word. - Combine both MGMT quality report command and event changes in a single patch. Changes in v3: - Swap AOSP Bluetooth Quality Report Event and Intel Telemetry Event. - Add 5 new patches (5/9 - 9/9) to enable the quality report feature via MGMT_OP_SET_QUALITY_REPORT instead of through the experimental features. Changes in v2: - This is a new patch for adding the event in doc/mgmt-api.txt doc/mgmt-api.txt | 60 ++++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 60 insertions(+) diff --git a/doc/mgmt-api.txt b/doc/mgmt-api.txt index ebe56afa4..a429f0ef3 100644 --- a/doc/mgmt-api.txt +++ b/doc/mgmt-api.txt @@ -332,6 +332,7 @@ Read Controller Information Command 15 Static Address 16 PHY Configuration 17 Wideband Speech + 18 Quality Report This command generates a Command Complete event on success or a Command Status event on failure. @@ -2924,6 +2925,7 @@ Read Extended Controller Information Command 15 Static Address 16 PHY Configuration 17 Wideband Speech + 18 Quality Report The EIR_Data field contains information about class of device, local name and other values. Not all of them might be present. For @@ -3858,6 +3860,45 @@ Add Advertisement Patterns Monitor With RSSI Threshold Command Invalid Parameters +Set Quality Report Command +========================== + + Command Code: 0x0057 + Controller Index: <controller id> + Command Parameters: Quality_Report (1 Octet) + Return Parameters: Current_Settings (4 Octets) + + This command is used to enable and disable the controller's quality + report feature. The allowed values for the Quality_Report command + parameter are 0x00 and 0x01. All other values will return Invalid + Parameters. + + The value 0x00 disables the Quality Report, and the value 0x01 + enables the Quality Report feature. + + This command is only available for the controllers that support + either AOSP Bluetooth quality report or Intel telemetry event. + It is supported if the supported_settings indicate support for it. + + This command requires to use a valid controller index. Otherwise, + an Invalid Index status will be returned. + + The command is sent to the controller to enable/disable the quality + report feature, and generates a Command Complete event on success. + If the controller failed to execute the action, a Failed status will + be returned. + + The quality report state is maintained by the kernel over the adapter + power cycle. When the adapter is powered off, the quality report + feature is disabled by the kernel. When the adapter is powered on, it + is enabled again by the kernel if it was enabled before. + + Possible errors: Failed + Invalid Index + Invalid Parameters + Not Supported + + Command Complete Event ====================== @@ -4978,3 +5019,22 @@ Advertisement Monitor Device Lost Event 2 LE Random This event will be sent to all management sockets. + + +Quality Report Event +==================== + + Event code: 0x0031 + Controller Index: <controller_id> + Event Parameters: Quality_Spec (1 Octet) + Report_Len (2 Octets) + Report (0-65535 Octets) + + This event carries the Bluetooth quality report sent by the + controller. + + Possible values for the Quality_Spec parameter: + 0 AOSP Bluetooth Quality Report Event + 1 Intel Telemetry Event + + This event will be sent to all management sockets. -- 2.36.1.124.g0e6072fb45-goog
