Re: [PATCH 1/2] dt-bindings: net: broadcom-bluetooth: Add property for autobaud mode

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Thu, May 5, 2022 at 3:11 PM Hakan Jansson <hakan.jansson@xxxxxxxxxxxx> wrote:

> I suppose a general flag could be useful but to be honest I don't know
> if any other devices besides the ones using the Broadcom driver has any
> use for it. You would probably also still want to be able to use
> current-speed to set the link speed and end up using both
> current-speed=x and current-speed-auto at the same time, which might
> look a little confusing?

I do not think it is more confusing than being able to use
current-speed and brcm,uses-autobaud-mode at the same time.

> Please let me know if you'd still prefer "current-speed-auto" over
> "brcm,uses-autobaud-mode" and I'll revise the patch and rename it!

It actually depends a bit.

This:

> >> +      The controller should be started in autobaud mode by asserting
> >> +      BT_UART_CTS_N (i.e. host RTS) during startup. Only HCI commands supported
> >> +      in autobaud mode should be used until patch FW has been loaded.

sounds a bit vague?

Does it mean that CTS is asserted, then you send a bit (CTS then goes low)
and then CTS is asserted again when the device is ready to receieve more
data? i.e is this some kind of one-bit mode, because it doesn't sound like
it is using CTS as it was used in legacy modems.

Some more explanation of this mode is needed so we can understand if
this is something generic or a BRCM-only thing.

Yours,
Linus Walleij



[Index of Archives]     [Bluez Devel]     [Linux Wireless Networking]     [Linux Wireless Personal Area Networking]     [Linux ATH6KL]     [Linux USB Devel]     [Linux Media Drivers]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Big List of Linux Books]

  Powered by Linux