Re: [PATCH 3/8] dt-bindings: net: bluetooth: Add rtl8723bs-bluetooth

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Fri, Jan 18, 2019 at 09:02:27AM -0800, Vasily Khoruzhick wrote:
> Add binding document for bluetooth part of RTL8723BS/RTL8723CS
> 
> Signed-off-by: Vasily Khoruzhick <anarsoul@xxxxxxxxx>
> ---
>  .../bindings/net/rtl8723bs-bluetooth.txt      | 35 +++++++++++++++++++
>  1 file changed, 35 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/net/rtl8723bs-bluetooth.txt
> 
> diff --git a/Documentation/devicetree/bindings/net/rtl8723bs-bluetooth.txt b/Documentation/devicetree/bindings/net/rtl8723bs-bluetooth.txt
> new file mode 100644
> index 000000000000..8357f242ae4c
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/net/rtl8723bs-bluetooth.txt
> @@ -0,0 +1,35 @@
> +RTL8723BS/RTL8723CS Bluetooth
> +---------------------
> +
> +RTL8723CS/RTL8723CS is WiFi + BT chip. WiFi part is connected over SDIO, while
> +BT is connected over serial. It speaks H5 protocol with few extra commands
> +to upload firmware and change module speed.
> +
> +Required properties:
> +
> + - compatible: should be one of the following:
> +   * "realtek,rtl8723bs-bt"
> +   * "realtek,rtl8723cs-bt"
> +Optional properties:
> +
> + - device-wake-gpios: GPIO specifier, used to wakeup the BT module (active high)
> + - enable-gpios: GPIO specifier, used to enable the BT module (active high)
> + - host-wake-gpios: GPIO specifier, used to wakeup the host processor (active high)
> + - firmware-postfix: firmware postfix to be used for firmware config

How is this used?

Rob




[Index of Archives]     [Bluez Devel]     [Linux Wireless Networking]     [Linux Wireless Personal Area Networking]     [Linux ATH6KL]     [Linux USB Devel]     [Linux Media Drivers]     [Linux Audio Users]     [Linux Kernel]     [Linux SCSI]     [Big List of Linux Books]

  Powered by Linux