On Thu, May 26, 2011 at 4:37 AM, Ville Tervo <ville.tervo@xxxxxxxxx> wrote: > On Wed, May 25, 2011 at 09:11:19PM -0400, ext Corey Boyle wrote: >> On Wed, May 25, 2011 at 12:31 PM, Tom Allebrandi <wyrles@xxxxxxxxx> wrote: >> > -----Original Message----- >> > From: linux-bluetooth-owner@xxxxxxxxxxxxxxx >> > [mailto:linux-bluetooth-owner@xxxxxxxxxxxxxxx] On Behalf Of Cufi, Carles >> > Sent: Wednesday, May 25, 2011 7:15 AM >> > To: corey@xxxxxxxxxxxxx >> > Cc: Ed Tomlinson; Ville Tervo; Bluettooth Linux; >> > linux-kernel@xxxxxxxxxxxxxxx >> > Subject: RE: Linux 2.6.39 >> > >> > (Snipping...) >> > On Wed, May 25, 2011 at 8:46 AM, Cufi, Carles <carles.cufi@xxxxxxxxxxxxx> >> > wrote: >> >> On Wednesday 25 May 2011 07:36:14 Ville Tervo wrote: >> >>> On Wed, May 25, 2011 at 07:11:17AM -0400, ext Ed Tomlinson wrote: >> >>> > On Wednesday 25 May 2011 06:54:54 Corey Boyle wrote: >> >>> > > > On Mon, May 23, 2011 at 06:08:36PM -0400, ext Ed Tomlinson wrote: >> >>> > > > > On Saturday 21 May 2011 16:31:00 Ed Tomlinson wrote: >> >>> > > > > > On Saturday 21 May 2011 13:56:20 Milan Oravec wrote: >> > ... >> >>> > Read Local Version Information (0x04|0x0001) plen 0 >> >>> > > HCI Event: Command Complete (0x0e) plen 12 >> >>> > Read Local Version Information (0x04|0x0001) ncmd 1 >> >>> > status 0x00 >> >>> > HCI Version: 1.1 (0x1) HCI Revision: 0x20d >> > ************************* >> >>> > LMP Version: 1.1 (0x1) LMP Subversion: 0x20d >> > ************************* >> >>> > Manufacturer: Cambridge Silicon Radio (10) < HCI Command: Set >> >>> > Event Mask (0x03|0x0001) plen 8 >> >>> > Mask: 0xfffffbff00000000 >> > ************************* >> >>> > > HCI Event: Command Complete (0x0e) plen 4 >> >>> > Set Event Mask (0x03|0x0001) ncmd 1 >> >>> > status 0x12 >> >>> > Error: Invalid HCI Command Parameters >> >> >> >>Set Event Mask has been in the Bluetooth Spec since day 1, so it must be >> > the bitmask, which has been extended with each new spec release to cover >> > newly >added events. Looking at the latest spec, and judging by the year >> > your chipset was released in (it probably is a 1.1 compliant chipset) I >> > believe that >0x000000008FFFFFFF is the highest event mask it would support >> > (up until and including Page Scan Repetition Mode Change Event), but since I >> > don't have the >old 1.1 spec around I may be one or two bits off. >> > >> > The device appears to have identified itself as CSR firmware using Bluetooth >> > version 1.1. >> > >> > I do happen to have the 1.1 spec lying around :-), for Set_Event_Mask it >> > says >> > >> > 0x0000000100000000 >> > To Reserved for future use >> > 0x8000000000000000 >> > >> > 0x00000000FFFFFFFF Default (All events enabled) >> > >> >> I am beginning to think that my adapter simply does not support this >> command. I have tried with all the suggested bitmasks, all zeros, all >> ones, all combinations where a single bit is set, etc. I'm not sure >> where to go from here other than add a flag which incidates that >> certain devices don't support this command so it can be skipped. >> Again, the only way I have gotten it to work is by not sending the >> command at all. Thoughts? > > I also played a bit with 1.1 CSR dongle and couldn't find any mask that would > be accepted. I think this command can be left out for older than 1.2 devices. > > Following patch should do it. Could you verify it. I don't have access to old > hw ATM. > > diff --git a/net/bluetooth/hci_event.c b/net/bluetooth/hci_event.c > index 19cd4af..86d1e26 100644 > --- a/net/bluetooth/hci_event.c > +++ b/net/bluetooth/hci_event.c > @@ -477,14 +477,16 @@ static void hci_setup_event_mask(struct hci_dev *hdev) > * command otherwise */ > u8 events[8] = { 0xff, 0xff, 0xfb, 0xff, 0x00, 0x00, 0x00, 0x00 }; > > - /* Events for 1.2 and newer controllers */ > - if (hdev->lmp_ver > 1) { > - events[4] |= 0x01; /* Flow Specification Complete */ > - events[4] |= 0x02; /* Inquiry Result with RSSI */ > - events[4] |= 0x04; /* Read Remote Extended Features Complete */ > - events[5] |= 0x08; /* Synchronous Connection Complete */ > - events[5] |= 0x10; /* Synchronous Connection Changed */ > - } > + /* CSR 1.1 dongles does not accept any bitfield so don't try to set > + * any event mask for pre 1.2 devices */ > + if (hdev->lmp_ver <= 1) > + return; > + > + events[4] |= 0x01; /* Flow Specification Complete */ > + events[4] |= 0x02; /* Inquiry Result with RSSI */ > + events[4] |= 0x04; /* Read Remote Extended Features Complete */ > + events[5] |= 0x08; /* Synchronous Connection Complete */ > + events[5] |= 0x10; /* Synchronous Connection Changed */ > > if (hdev->features[3] & LMP_RSSI_INQ) > events[4] |= 0x04; /* Inquiry Result with RSSI */ > -- > > Patch works great - typing this email from my bluetooth keyboard. -- To unsubscribe from this list: send the line "unsubscribe linux-bluetooth" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
