On Wed, May 25, 2011 at 09:11:19PM -0400, ext Corey Boyle wrote: > On Wed, May 25, 2011 at 12:31 PM, Tom Allebrandi <wyrles@xxxxxxxxx> wrote: > > -----Original Message----- > > From: linux-bluetooth-owner@xxxxxxxxxxxxxxx > > [mailto:linux-bluetooth-owner@xxxxxxxxxxxxxxx] On Behalf Of Cufi, Carles > > Sent: Wednesday, May 25, 2011 7:15 AM > > To: corey@xxxxxxxxxxxxx > > Cc: Ed Tomlinson; Ville Tervo; Bluettooth Linux; > > linux-kernel@xxxxxxxxxxxxxxx > > Subject: RE: Linux 2.6.39 > > > > (Snipping...) > > On Wed, May 25, 2011 at 8:46 AM, Cufi, Carles <carles.cufi@xxxxxxxxxxxxx> > > wrote: > >> On Wednesday 25 May 2011 07:36:14 Ville Tervo wrote: > >>> On Wed, May 25, 2011 at 07:11:17AM -0400, ext Ed Tomlinson wrote: > >>> > On Wednesday 25 May 2011 06:54:54 Corey Boyle wrote: > >>> > > > On Mon, May 23, 2011 at 06:08:36PM -0400, ext Ed Tomlinson wrote: > >>> > > > > On Saturday 21 May 2011 16:31:00 Ed Tomlinson wrote: > >>> > > > > > On Saturday 21 May 2011 13:56:20 Milan Oravec wrote: > > ... > >>> > Read Local Version Information (0x04|0x0001) plen 0 > >>> > > HCI Event: Command Complete (0x0e) plen 12 > >>> > Read Local Version Information (0x04|0x0001) ncmd 1 > >>> > status 0x00 > >>> > HCI Version: 1.1 (0x1) HCI Revision: 0x20d > > ************************* > >>> > LMP Version: 1.1 (0x1) LMP Subversion: 0x20d > > ************************* > >>> > Manufacturer: Cambridge Silicon Radio (10) < HCI Command: Set > >>> > Event Mask (0x03|0x0001) plen 8 > >>> > Mask: 0xfffffbff00000000 > > ************************* > >>> > > HCI Event: Command Complete (0x0e) plen 4 > >>> > Set Event Mask (0x03|0x0001) ncmd 1 > >>> > status 0x12 > >>> > Error: Invalid HCI Command Parameters > >> > >>Set Event Mask has been in the Bluetooth Spec since day 1, so it must be > > the bitmask, which has been extended with each new spec release to cover > > newly >added events. Looking at the latest spec, and judging by the year > > your chipset was released in (it probably is a 1.1 compliant chipset) I > > believe that >0x000000008FFFFFFF is the highest event mask it would support > > (up until and including Page Scan Repetition Mode Change Event), but since I > > don't have the >old 1.1 spec around I may be one or two bits off. > > > > The device appears to have identified itself as CSR firmware using Bluetooth > > version 1.1. > > > > I do happen to have the 1.1 spec lying around :-), for Set_Event_Mask it > > says > > > > 0x0000000100000000 > > To Reserved for future use > > 0x8000000000000000 > > > > 0x00000000FFFFFFFF Default (All events enabled) > > > > I am beginning to think that my adapter simply does not support this > command. I have tried with all the suggested bitmasks, all zeros, all > ones, all combinations where a single bit is set, etc. I'm not sure > where to go from here other than add a flag which incidates that > certain devices don't support this command so it can be skipped. > Again, the only way I have gotten it to work is by not sending the > command at all. Thoughts? I also played a bit with 1.1 CSR dongle and couldn't find any mask that would be accepted. I think this command can be left out for older than 1.2 devices. Following patch should do it. Could you verify it. I don't have access to old hw ATM. diff --git a/net/bluetooth/hci_event.c b/net/bluetooth/hci_event.c index 19cd4af..86d1e26 100644 --- a/net/bluetooth/hci_event.c +++ b/net/bluetooth/hci_event.c @@ -477,14 +477,16 @@ static void hci_setup_event_mask(struct hci_dev *hdev) * command otherwise */ u8 events[8] = { 0xff, 0xff, 0xfb, 0xff, 0x00, 0x00, 0x00, 0x00 }; - /* Events for 1.2 and newer controllers */ - if (hdev->lmp_ver > 1) { - events[4] |= 0x01; /* Flow Specification Complete */ - events[4] |= 0x02; /* Inquiry Result with RSSI */ - events[4] |= 0x04; /* Read Remote Extended Features Complete */ - events[5] |= 0x08; /* Synchronous Connection Complete */ - events[5] |= 0x10; /* Synchronous Connection Changed */ - } + /* CSR 1.1 dongles does not accept any bitfield so don't try to set + * any event mask for pre 1.2 devices */ + if (hdev->lmp_ver <= 1) + return; + + events[4] |= 0x01; /* Flow Specification Complete */ + events[4] |= 0x02; /* Inquiry Result with RSSI */ + events[4] |= 0x04; /* Read Remote Extended Features Complete */ + events[5] |= 0x08; /* Synchronous Connection Complete */ + events[5] |= 0x10; /* Synchronous Connection Changed */ if (hdev->features[3] & LMP_RSSI_INQ) events[4] |= 0x04; /* Inquiry Result with RSSI */ -- -- To unsubscribe from this list: send the line "unsubscribe linux-bluetooth" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
