Can someone please advise me further on this please? There is no binary called "l2test" in the 4.91 sources. It's crucial I get this problem remedied as I can't send data between two HCI devices. This could be a bug in BlueZ... On Thu, May 12, 2011 at 11:19 AM, Eponymous - <the.epon@xxxxxxxxx> wrote: > Hi, > > I've just downloaded the 4.91 sources and done a make and the only > program I can see starting "l2" is "l2ping". There is no l2test. > > > On Wed, May 11, 2011 at 5:47 PM, Gustavo F. Padovan > <padovan@xxxxxxxxxxxxxx> wrote: >> * Eponymous - <the.epon@xxxxxxxxx> [2011-05-11 09:52:28 +0100]: >> >>> Hi, >>> >>> I've ran into an issue where data doesn't seem to be received by a slave device. >>> >>> I do the following: >>> >>> Using Gentoo Linux (2.6.34-gentoo-r1) >>> Using BlueZ 4.81 >>> >>> 1. Use BlueZ to connect to two Bluetooth devices using HCI only. This >>> is over USB. >>> >>> 2. I set one device as a slave and then create a connection between >>> the two. This completes sucessfully and can be seen on both sides. >>> >>> 3. I then try to send an acl packet with the word "hi" in it and it is >>> not received on the other side. >> >> There a utility called l2test in the bluez sources. Check if it works for you. >> Using -r in one side to listen and -s in the other side to send data. Or >> l2test -h and see all options. >> >> -- >> Gustavo F. Padovan >> http://profusion.mobi >> > -- To unsubscribe from this list: send the line "unsubscribe linux-bluetooth" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
