Hi, I've ran into an issue where data doesn't seem to be received by a slave device. I do the following: Using Gentoo Linux (2.6.34-gentoo-r1) Using BlueZ 4.81 1. Use BlueZ to connect to two Bluetooth devices using HCI only. This is over USB. 2. I set one device as a slave and then create a connection between the two. This completes sucessfully and can be seen on both sides. 3. I then try to send an acl packet with the word "hi" in it and it is not received on the other side. -------- Doing the same thing above but: Using Fedora Core 5 (2.6.20-1.2320.fc5) And: bluez-libs-2.25-1 bluez-pin-0.30-2 bluez-utils-2.25-4 bluez-libs-devel-2.25-1 bluez-hcidump-1.30-1 and using the same hardware - the problem doesn't happen. I have attached two HCI dumps, one of the Master device and one of the Slave. Thanks for any help you can give.
Attachment:
master.out
Description: Binary data
Attachment:
slave.out
Description: Binary data
