On 02/05/2024 16:06, Zijun Hu wrote:
> Commit 272970be3dab ("Bluetooth: hci_qca: Fix driver shutdown on closed
> serdev") will cause below regression issue:
>
> BT can't be enabled after below steps:
> cold boot -> enable BT -> disable BT -> warm reboot -> BT enable failure
> if property enable-gpios is not configured within DT|ACPI for QCA6390.
>
> The commit is to fix a use-after-free issue within qca_serdev_shutdown()
> during reboot, but also introduces this regression issue regarding above
> steps since the VSC is not sent to reset controller during warm reboot.
>
> Fixed by sending the VSC to reset controller within qca_serdev_shutdown()
> once BT was ever enabled, and the use-after-free issue is also be fixed
> by this change since serdev is still opened when send to serdev.
>
> Fixes: 272970be3dab ("Bluetooth: hci_qca: Fix driver shutdown on closed serdev")
> Cc: stable@xxxxxxxxxxxxxxx
> Reported-by: Wren Turkal <wt@xxxxxxxxxxxxxxxx>
> Closes: https://bugzilla.kernel.org/show_bug.cgi?id=218726
> Signed-off-by: Zijun Hu <quic_zijuhu@xxxxxxxxxxx>
> Tested-by: Wren Turkal <wt@xxxxxxxxxxxxxxxx>
> ---
> drivers/bluetooth/hci_qca.c | 5 ++---
I don't think this is v1. Version your patches properly and provide
changelog.
I asked already *two times*:
1. On which kernel did you test it?
2. On which hardware did you test it?
I am not interested in any replies like "I wrote something on bugzilla".
I am really fed up with your elusive, time-wasting replies, so be
specific here.
Best regards,
Krzysztof
