On Fri, Sep 10, 2010 at 3:01 PM, Pavan Savoy <pavan_savoy@xxxxxxxx> wrote: > No, I don't suppose my controller was in a advertising state.. even if > it was why the return 0x0c? (command disallowed ..) > > I wanted to know whether you have some HCI-VS commands which sort of > enable the LE (AMP/radio/controller) ? > Is it only then the leadv command works? Or does it just works right-away. > I have one of those all in 1 chips.. bt/fm-rx-tx/gps so I am wondering > should I do something to enable BLE and is it some sort of un-spoken > standard? Does LE scan work for this same hardware? Do you have some windows software to test this hardware ? if so, you can try putting one device in advertise mode there , then attempt lescan on the other (from linux)... If it works, most probably the hardware might require some initialization... At least some hardware requires firmware upload and vendor specific one-time initialization which (I think) is out of scope for hciconfig. Regards, -- Anderson Lizardo OpenBossa Labs - INdT Manaus - Brazil -- To unsubscribe from this list: send the line "unsubscribe linux-bluetooth" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
