No, I don't suppose my controller was in a advertising state.. even if it was why the return 0x0c? (command disallowed ..) I wanted to know whether you have some HCI-VS commands which sort of enable the LE (AMP/radio/controller) ? Is it only then the leadv command works? Or does it just works right-away. I have one of those all in 1 chips.. bt/fm-rx-tx/gps so I am wondering should I do something to enable BLE and is it some sort of un-spoken standard? On Fri, Sep 10, 2010 at 1:14 PM, Anderson Briglia <anderson.briglia@xxxxxxxxxxxxx> wrote: > On 09/10/2010 12:53 PM, Pavan Savoy wrote: >> >> Nope, I haven't applied the kernel patches... >> But my kernel diff to the latest kernel is only regarding the "block" >> and "unblock" to black list devices.... >> >> do I need some patches in kernel for enabling/disabling BLE too ? >> I thought it just sends out the commands to controller... >> > > You are right. You don't need to have the kernel patches. > I did some tests here and everything goes ok. > Check the hcidump output below: > > 2010-09-10 14:13:19.032099 < HCI Command: Unknown (0x08|0x000a) plen 1 > 0000: 01 . > 2010-09-10 14:13:19.070320 > HCI Event: Command Complete (0x0e) plen 4 > Unknown (0x08|0x000a) ncmd 2 > 0000: 00 > > I just did a hciconfig hci0 leadv > > Regards, > > Anderson Briglia >> >> On Fri, Sep 10, 2010 at 8:40 AM, Anderson Briglia >> <anderson.briglia@xxxxxxxxxxxxx> wrote: >> >>> >>> Hi Pavan, >>> >>> Try to make a hciconfig reset before setting leadv. >>> Are you using that kernel patches I send before, right? >>> >>> Regards, >>> >>> Anderson Briglia >>> >>> On 09/09/2010 03:58 PM, Pavan Savoy wrote: >>> >>>> >>>> I have an LE enabled BT controller, and I happened to send across a >>>> simple "leadv" from the recently updated hciconfig >>>> I got back the following data >>>> "4 e 5 1 a 20 c 3a" and hence >>>> "Can't set advertise mode on hci0: Success (0)" >>>> and 0xC I guess by the BT spec means the command is disallowed (for >>>> reasons unknown?....) >>>> >>>> So I'm just wondering, am I supposed to run some HCI-VS commands to >>>> enable LE? I mean I should ask my vendor I agree, but anyone who has >>>> got it working.. do they run some VS commands before enabling LE >>>> advertising? >>>> -- >>>> To unsubscribe from this list: send the line "unsubscribe >>>> linux-bluetooth" >>>> in >>>> the body of a message to majordomo@xxxxxxxxxxxxxxx >>>> More majordomo info at http://vger.kernel.org/majordomo-info.html >>>> >>>> >>> >>> > > -- To unsubscribe from this list: send the line "unsubscribe linux-bluetooth" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html
