On Sun, Apr 07, 2013 at 11:30:52AM -0600, Bearcat M. Şándor wrote: > Most recent CDs were mastered digitally, therefore is the original > master equivalent (at least in quality) to the CD i own? Depends on what is meant by 'mastering'. If it just means preparing the metadata etc. required to press a CD, the answer would be 'yes', apart from the fact that the original probably has more than 16 bits, and maybe a higher sample rate. Which is more or less irrelevant if the recoding to 16 bits was properly dithered and resampled. If 'mastering' means applying EQ, compression etc. then the answer is 'no'. But for a CD that should not be necessary as the medium doesn't impose any technical limits that are more stringent that the artistic ones applied anyway while mixing. That is completely different to the situation that existed for analog media. Digital production tools make it easy to have more than one 'master', (depending on intended use) so the concept of a unique master doesn't always apply. I do a lot of 'contemporary classic' recordings, a type of music that tends to have a rather high dynamic range. I keep a fully edited Ardour session which will in general not have much dynamic processing applied, just some manual adjustments if necessary, and maybe a few dB of peak limiting which will be active only on short occasional peaks. That session could be called 'the master', but even everything done there is reversible, so it doesn't need to be final. Many of these recordings end up on Italian and other European radio networks, and most copies I prepare for that use have some compression (1:1.3 or so) applied to reduce the dynamic range. As far as the RAI and EBU are concerned, those versions are the 'master'. > At about what year did most CDs become digitally mastered, rendering > original master recordings moot, if they are? Anthing *recorded* the last 20 years at least has a very high chance of being entirely digital. Note 'recorded', not 'released'. > I *swear* i remember buying CDs when they came out and they used to tell > you how things were mastered. Didn't they used to indicate AAD, ADD, DDD > for (recording, editing, mastering)? Why did they stop doing this? Because it became irrelevant, or - in the case of re-released 'vintage' recordings from the pre-digital era - either obvious or a bad idea from a commercial perspective. > Is there any way to tell/reasonably guess if a CD has been digitally > mastered without those codes? See above, look at the recording dates. Exceptions will probably be noted in the booklet or credits. Ciao, -- FA A world of exhaustive, reliable metadata would be an utopia. It's also a pipe-dream, founded on self-delusion, nerd hubris and hysterically inflated market opportunities. (Cory Doctorow) _______________________________________________ Linux-audio-user mailing list Linux-audio-user@xxxxxxxxxxxxxxxxxxxx http://lists.linuxaudio.org/listinfo/linux-audio-user
