rob canning wrote : > Hi Thomas, > > hdsploader cand find my card for some reason: > > hdsploader: > [root@localhost robcanning]# hdsploader > hdsploader - firmware loader for RME Hammerfall DSP cards > Looking for HDSP + Multiface or Digiface cards : > Card 0 : Intel ICH5 at 0xfebfb800, irq 5 > > yet lspci -vv reveals: > > 03:0c.0 Multimedia audio controller: Xilinx Corporation RME Hammerfall DSP (rev > 32) > Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping+ SERR+ FastB2B- > Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- > Latency: 64 > Interrupt: pin A routed to IRQ 5 > Region 0: Memory at feae0000 (32-bit, non-prefetchable) [size=64K] > > > thanks, > > rob Hi Rob, You should first check if the module was properly loaded (/sbin/lsmod), then check you modules.conf file. In one of your previous mails one hdsp line looked dodgy : alias snd-card-0ntitlntitled 1ntitled 1ed 1 snd-hdsp Maybe you should run alsaconf again to start from a clean basis. Hope this helps, Thomas
