hi, still concerned with the issue that zita-a2j doesn't work properly on my computers (I’ve also tried it with another machine, both run arch linux) I enabled zita-a2j in verbose mode which tells me: playback : not enabled capture : nchan : 2 fsamp : 48000 fsize : 256 nfrag : 2 format : S16_LE whilst "playback" is indicated to be disabled, "capture" lacks a state, at all. could this be a useful hint for solving the problem? I have uninstalled zita-ajbridge, restartet and reinstalled, but the problem persists. by the way, I tried also if playback works (zita-j2a), but in the same manner it doesn't, i. e. zita-j2a shows up in jack’s graph and in the daw, but there is no signal. thanks in advance for any suggestion. christoph Am Montag, den 16.12.2019, 19:28 +0100 schrieb soffioalcuore@xxxxxxxxxx: > dear Len, thanks for replying! > > Am Montag, den 16.12.2019, 08:18 -0800 schrieb Len Ovens: > > On Mon, 16 Dec 2019, soffioalcuore@xxxxxxxxxx wrote: > > > > > #zita-a2j -d hw:H4 -r 48000 -p 512 -n 2 > > > > does the # mean you are running things as root? Jack and zita > > should > > only > > ever be run as a regular user and never as root/system. > > no, # was just to identify the following as code/terminal output. > sorry > for the confusion, now I'm aware I should better use $ for that. > > > > and I can see the zita-bridge both in the graph window of > > > qjackctl > > > and > > > in my daw (reaper). > > > the problem is that I don't get any signal from the device > > > connected by > > > the zita-bridge. I have also tried to change both devices - > > > without > > > success. furthermore, I've tried to leave some of the parameters > > > (-p > > > and -n) out. > > > > By no signal you mean there is a mic on the input but the audio > > does > > not > > show up? (The meters on the device itself show level?) > > exactly, that there's a signal (physically) incoming is indicated in > the 2nd device (and also in the 1st, as usual) but not in the daw, i. > e. its meters (but in the 1st). if I record from both devices, only > 1st/master device's tracks have the signals/content, but the tracks > of > the 2nd/slave device are empty. > > > Does the signal ever show up on each device A) when not running > > jack? > > B) > > as the sole jack master? > > a) yes, they normally do. > b) yes. > > > Is the device you are using as jack master also the device you are > > using > > for monitoring? (output to speakers/heagphones?) > > yes, by now, the master device is, as usual, the monitoring device. > for > the moment I'm just focussing on the inputs. > > > -- > > Len Ovens > > www.ovenwerks.net > > I hope that helps. thanks again! > christoph > _______________________________________________ > Linux-audio-user mailing list > Linux-audio-user@xxxxxxxxxxxxxxxxxxxx > https://lists.linuxaudio.org/listinfo/linux-audio-user _______________________________________________ Linux-audio-user mailing list Linux-audio-user@xxxxxxxxxxxxxxxxxxxx https://lists.linuxaudio.org/listinfo/linux-audio-user
