Hi,
Long story short, I am messing with my audio on a UbuntuStudio 16.04 laptop.
I had it setup to use XUSB from my X32...
I
want to do some work without the X32, so I said, self, just fire up
Qjackctl and set it back so the config with a Pulse sink/source and the
system output is going to the local hardware.
Except,
the default config has been lost. After some messing around, I get the
pulse source/sink, but audio is not routed to the local speakers (this
is a laptop).
Patchage shows the pulse sink
connected to system/playback and if I play audio from an app (for
example clementine) configured to the pulse sink, it shows signal in the
Output Devices tab in volume control on the pulse sink.
Basically, as far as I can tell, I've managed to screw up my audio config on this PC.
I admit the sound configuration on linux has been my nemesis for years...
After
much googling and reading until eyes are blurry...I could use some
ideas on what to look at or how to figure out what I f'd up.
:(
Regards,
Mac
_______________________________________________ Linux-audio-user mailing list Linux-audio-user@xxxxxxxxxxxxxxxxxxxx https://lists.linuxaudio.org/listinfo/linux-audio-user
