I can tell you that there are old fashioned physical jumpers on the Delta 1010LT card that you are supposed to set one way for line-level and another way for mic-level input. One set of jumpers for each of the two lines that have mic pre-amps on board. On Tuesday 23 September 2003 11:06 am, Greg Reddin wrote: > Does anyone know if the ADC 0 and ADC 1 controls on envy24control > actually control the preamp gain on the M-Audio Delta 1010LT or would > it just be the AD converter levels? > > My eventual goal is to use my DAW as a PA processor for small road > gigs using Freqtweak or something similar for the master EQ and > dynamics processing for FOH and monitors. As a proof of concept I > connected the XLR outputs of an Allen & Heath console to the XLR > inputs of my Delta 1010LT and connected the outputs of the Delta > 1010LT to the power amp. I was not able to get good levels without > distortion and I suspect it is because I need to decrease the gain on > the mic preamps in the 1010LT. I would've connected to the > line-level RCA inputs, but I didn't have a cable handy to try that. > > The problem seemed to persist even if I lowered the faders on the > console. So does the preamp gain sound suspicious or am I connecting > something with too much of an output level to a mic preamp to begin > with or does it seem like something else? I'm pretty sure I'm not > driving the amps with too much level frin the DAW. > > Any help is greatly appreciated. > Greg > > > > > __________________________________ > Do you Yahoo!? > Yahoo! SiteBuilder - Free, easy-to-use web site design software > http://sitebuilder.yahoo.com
