From: Jonathan Marek <jonathan@xxxxxxxx>
Use the decode_format/data_type from the "format" struct instead of a
hardcoded 10-bit format.
Fixes: eebe6d00e9bf ("media: camss: Add support for CSID hardware version Titan 170")
Signed-off-by: Jonathan Marek <jonathan@xxxxxxxx>
Reviewed-by: Robert Foss <robert.foss@xxxxxxxxxx>
Tested-by: Julian Grahsl <jgrahsl@xxxxxxxx>
Tested-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@xxxxxxxxxx>
---
drivers/media/platform/qcom/camss/camss-csid-170.c | 5 +++--
1 file changed, 3 insertions(+), 2 deletions(-)
diff --git a/drivers/media/platform/qcom/camss/camss-csid-170.c b/drivers/media/platform/qcom/camss/camss-csid-170.c
index ac22ff29d2a9..aa65043c3303 100644
--- a/drivers/media/platform/qcom/camss/camss-csid-170.c
+++ b/drivers/media/platform/qcom/camss/camss-csid-170.c
@@ -366,7 +366,7 @@ static void csid_configure_stream(struct csid_device *csid, u8 enable)
val |= input_format->width & 0x1fff << TPG_DT_n_CFG_0_FRAME_WIDTH;
writel_relaxed(val, csid->base + CSID_TPG_DT_n_CFG_0(0));
- val = DATA_TYPE_RAW_10BIT << TPG_DT_n_CFG_1_DATA_TYPE;
+ val = format->data_type << TPG_DT_n_CFG_1_DATA_TYPE;
writel_relaxed(val, csid->base + CSID_TPG_DT_n_CFG_1(0));
val = tg->mode << TPG_DT_n_CFG_2_PAYLOAD_MODE;
@@ -382,8 +382,9 @@ static void csid_configure_stream(struct csid_device *csid, u8 enable)
val = 1 << RDI_CFG0_BYTE_CNTR_EN;
val |= 1 << RDI_CFG0_FORMAT_MEASURE_EN;
val |= 1 << RDI_CFG0_TIMESTAMP_EN;
+ /* note: for non-RDI path, this should be format->decode_format */
val |= DECODE_FORMAT_PAYLOAD_ONLY << RDI_CFG0_DECODE_FORMAT;
- val |= DATA_TYPE_RAW_10BIT << RDI_CFG0_DATA_TYPE;
+ val |= format->data_type << RDI_CFG0_DATA_TYPE;
val |= vc << RDI_CFG0_VIRTUAL_CHANNEL;
val |= dt_id << RDI_CFG0_DT_ID;
writel_relaxed(val, csid->base + CSID_RDI_CFG0(0));
--
2.33.0
