On 25-10-21, 17:40, Dmitry Baryshkov wrote:
> On 20/10/2021 09:57, Vinod Koul wrote:
> > On 14-10-21, 16:50, Dmitry Baryshkov wrote:
> > > On 14/10/2021 16:41, Dmitry Baryshkov wrote:
> > > > On 07/10/2021 10:08, Vinod Koul wrote:
> > > > > diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_ctl.h
> > > > > b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_ctl.h
> > > > > index 806c171e5df2..5dfac5994bd4 100644
> > > > > --- a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_ctl.h
> > > > > +++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_ctl.h
> > > > > @@ -39,6 +39,7 @@ struct dpu_hw_stage_cfg {
> > > > > * @mode_3d: 3d mux configuration
> > > > > * @merge_3d: 3d merge block used
> > > > > * @intf_mode_sel: Interface mode, cmd / vid
> > > > > + * @dsc: DSC BIT masks
> > > > > * @stream_sel: Stream selection for multi-stream interfaces
> > > > > */
> > > > > struct dpu_hw_intf_cfg {
> > > > > @@ -46,6 +47,7 @@ struct dpu_hw_intf_cfg {
> > > > > enum dpu_3d_blend_mode mode_3d;
> > > > > enum dpu_merge_3d merge_3d;
> > > > > enum dpu_ctl_mode_sel intf_mode_sel;
> > > > > + unsigned int dsc;
> > >
> > > I think this should be:
> > > enum dpu_dsc dsc[MAX_DSCS];
> > > unsigned int num_dsc;
> >
> > hmmm, how do we go about getting the num_dsc value here.
> > dpu_encoder_phys does not know about that..
>
> dpu_encoder_get_topology() can decide whether to use DSC or not and then set
> num_dsc. For now it will always set 2 if we are using DSC at all, but let's
> keep the decision in a single place rather than having it scattered all over
> the driver.
Yes agree, but dpu_encoder_get_topology() is private to encoder. Am not
sure how best to propagate the info into the hw_intf_cfg?
--
~Vinod
